Water hardness in Whitman County, WA
Water in Whitman County is moderately hard, with a median of 114 mg/L (6.7 grains per gallon) across 13 monitoring sites.
Whitman County water at a glance
- HardnessModerately hard (114 mg/L, 6.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 114 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.7 gpg (6.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Whitman County
Prefilled with Whitman County's measured local hardness of 114 mg/L (6.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Whitman County on the Washington map
Cities and communities in Whitman County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Pullman | 114 | Moderately hard | county median |
| Colfax | 122 | Hard | 4 sites within 10 miles |
| Palouse | 114 | Moderately hard | county median |
| Tekoa | 114 | Moderately hard | county median |
| Rosalia | 114 | Moderately hard | county median |
| St. John | 114 | Moderately hard | county median |
| Garfield | 110 | Moderately hard | 5 sites within 10 miles |
| Albion | 111 | Moderately hard | 3 sites within 10 miles |
| Colton | 114 | Moderately hard | county median |
| Oakesdale | 110 | Moderately hard | 3 sites within 10 miles |
| Uniontown | 197 | Very hard | 3 sites within 10 miles |
| Endicott | 114 | Moderately hard | county median |
| LaCrosse | 114 | Moderately hard | county median |
| Malden | 114 | Moderately hard | county median |
| Steptoe (CDP) | 110 | Moderately hard | 3 sites within 10 miles |
| Farmington | 110 | Moderately hard | 3 sites within 10 miles |
| Lamont | 114 | Moderately hard | county median |
Water quality in Whitman County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Pullman | City of Pullman Water Department | None detected | 0 lead · 0 unknown | None |
| Colfax | City of Colfax Water Department | None detected | 0 lead · 721 unknown | None |
| Palouse | City of Palouse Water Dept | Not tested | 0 lead · 92 unknown | None |
| Tekoa | City of Tekoa | Not tested | 1 lead · 342 unknown | None |
| Rosalia | Town of Rosalia | Not tested | 0 lead · 0 unknown | None |
| St. John | Town of ST John | Not tested | 0 lead · 0 unknown | None |
| Garfield | Garfield Water Department | Not tested | 0 lead · 0 unknown | None |
| Albion | Albion Water Dept | Not tested | 0 lead · 0 unknown | None |
| Colton | Colton Water Department | Not tested | 0 lead · 0 unknown | None |
| Oakesdale | Town of Oakesdale | Not tested | Not reported | None |
| Uniontown | Uniontown Water Works | Not tested | 0 lead · 0 unknown | None |
| Endicott | Endicott Water Dept | Not tested | Not reported | None |
| LaCrosse | Town of Lacrosse | Not tested | 0 lead · 230 unknown | None |
| Malden | Malden Water Dept | Not tested | 0 lead · 0 unknown | None |
| Steptoe | Steptoe Water/Sewer District | Not tested | 0 lead · 70 unknown | None |
| Farmington | Farmington Water Dept | Not tested | 0 lead · 90 unknown | None |
| Lamont | Lamont Water System | Not tested | Not reported | None |
Neighboring counties
- Garfield County114 mg/L
- Adams County233 mg/L
- Spokane County24 mg/L
- Asotin County96 mg/L
- Lincoln County178 mg/L
- Walla Walla County66 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.