Water hardness in Kittitas County, WA

Water in Kittitas County is soft, with a median of 44 mg/L (2.6 grains per gallon) across 23 monitoring sites.

41% softer than the Washington median (74 mg/L) 26th hardest of 35 counties
44mg/L
2.6 grains per gallon
Soft

Kittitas County water at a glance

  • HardnessSoft (44 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 44 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites23
Lab samples33
Sample years2010–2016
Middle 50% of sites24–106 mg/L
Groundwater (wells, springs)44 mg/L · 21 sites
Surface water (rivers, lakes)55 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Kittitas County

Prefilled with Kittitas County's measured local hardness of 44 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Kittitas County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Kittitas County

PlaceMedian mg/LClassBased on
Ellensburg 44 Soft county median
Cle Elum 32 Soft 12 sites within 10 miles
Kittitas 44 Soft county median
Roslyn 28 Soft 8 sites within 10 miles
South Cle Elum 32 Soft 12 sites within 10 miles
Easton (CDP) 28 Soft 8 sites within 10 miles
Snoqualmie Pass (CDP) 44 Soft county median
Ronald (CDP) 71 Moderately hard 8 sites within 10 miles
Thorp (CDP) 92 Moderately hard 4 sites within 10 miles
Vantage (CDP) 44 Soft county median

Water quality in Kittitas County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Ellensburg Ellensburg Water Dept None detected 0 lead · 2,871 unknown None
Cle Elum Cle Elum Water Department Not tested 0 lead · 991 unknown None
Kittitas City of Kittitas Not tested 0 lead · 0 unknown None
Roslyn City of Roslyn Not tested 0 lead · 617 unknown None
South Cle Elum South Cle Elum Water Dept Not tested Not reported None
Easton Easton Water District Not tested 0 lead · 0 unknown None
Snoqualmie Pass Snoqualmie Pass Utility District None detected 0 lead · 22 unknown None
Vantage Vantage Water System Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next