Water hardness in Ferry County, WA

Water in Ferry County is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 13 monitoring sites.

43% harder than the Washington median (74 mg/L) 11th hardest of 35 counties
106mg/L
6.2 grains per gallon
Moderately hard

Ferry County water at a glance

  • HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 106 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites13
Lab samples129
Sample years2000–2014
Middle 50% of sites84–180 mg/L
Groundwater (wells, springs)134 mg/L · 10 sites
Surface water (rivers, lakes)71 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Ferry County

Prefilled with Ferry County's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Ferry County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Ferry County

PlaceMedian mg/LClassBased on
Republic 106 Moderately hard county median
Curlew Lake (CDP) 106 Moderately hard county median
Inchelium (CDP) 135 Hard 6 sites within 10 miles
Keller (CDP) 114 Moderately hard 5 sites within 10 miles
Barney's Junction (CDP) 106 Moderately hard county median
Pine Grove (CDP) 106 Moderately hard county median
Curlew (CDP) 106 Moderately hard county median
Orient (CDP) 106 Moderately hard county median
Barstow (CDP) 81 Moderately hard 3 sites within 10 miles
Twin Lakes (CDP) 180 Hard 5 sites within 10 miles
Torboy (CDP) 106 Moderately hard county median
Boyds (CDP) 81 Moderately hard 3 sites within 10 miles
Danville (CDP) 106 Moderately hard county median
Malo (CDP) 106 Moderately hard county median
Laurier (CDP) 106 Moderately hard county median

Water quality in Ferry County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Republic City of Republic Not tested 0 lead · 80 unknown None
Inchelium Inchelium Water District Not tested 0 lead · 0 unknown 1
Curlew Curlew Water & Sewer District Not tested 0 lead · 3 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next