Water hardness in Asotin County, WA

Water in Asotin County is moderately hard, with a median of 96 mg/L (5.6 grains per gallon) across 2 monitoring sites.

30% harder than the Washington median (74 mg/L) 12th hardest of 35 counties
96mg/L
5.6 grains per gallon
Moderately hard

Asotin County water at a glance

  • HardnessModerately hard (96 mg/L, 5.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 96 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.6 gpg (5.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites2
Lab samples2
Sample years2009–2016
Middle 50% of sites79–113 mg/L
Groundwater (wells, springs)62 mg/L · 1 sites
Surface water (rivers, lakes)130 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Asotin County

Prefilled with Asotin County's measured local hardness of 96 mg/L (5.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Asotin County on the Washington map

King CountyLincoln CountyPend Oreille CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Asotin County

PlaceMedian mg/LClassBased on
Clarkston 164 Hard 4 sites within 10 miles
Clarkston Heights-Vineland (CDP) 164 Hard 4 sites within 10 miles
West Clarkston-Highland (CDP) 164 Hard 4 sites within 10 miles
Asotin 164 Hard 4 sites within 10 miles
Anatone (CDP) 96 Moderately hard county median

Water quality in Asotin County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Asotin Asotin Water Dept Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next