Water hardness in Clallam County, WA

Water in Clallam County is soft, with a median of 51 mg/L (3 grains per gallon) across 3 monitoring sites.

31% softer than the Washington median (74 mg/L) 23rd hardest of 35 counties
51mg/L
3 grains per gallon
Soft

Clallam County water at a glance

  • HardnessSoft (51 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 51 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites3
Lab samples5
Sample years2006–2008
Middle 50% of sites50–65 mg/L
Groundwater (wells, springs)80 mg/L · 1 sites
Surface water (rivers, lakes)50 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Clallam County

Prefilled with Clallam County's measured local hardness of 51 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Clallam County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Clallam County

PlaceMedian mg/LClassBased on
Port Angeles 51 Soft county median
Sequim 51 Soft county median
Forks 51 Soft county median
Port Angeles East (CDP) 51 Soft county median
Carlsborg (CDP) 51 Soft county median
Neah Bay (CDP) 51 Soft county median
Bell Hill (CDP) 51 Soft county median
River Road (CDP) 51 Soft county median
Clallam Bay (CDP) 51 Soft county median
Jamestown (CDP) 51 Soft county median
Blyn (CDP) 51 Soft county median
Sekiu (CDP) 51 Soft county median

Water quality in Clallam County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Port Angeles City of Port Angeles None detected 0 lead · 2,052 unknown None
Sequim City of Sequim 1 found 0 lead · 305 unknown None
Forks Forks Municipal Water Dept None detected 0 lead · 1,450 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next