Water hardness in Stevens County, WA

Water in Stevens County is moderately hard, with a median of 73 mg/L (4.3 grains per gallon) across 15 monitoring sites.

about the same as the Washington median (74 mg/L) 15th hardest of 35 counties
73mg/L
4.3 grains per gallon
Moderately hard

Stevens County water at a glance

  • HardnessModerately hard (73 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 73 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites15
Lab samples73
Sample years2000–2012
Middle 50% of sites64–82 mg/L
Groundwater (wells, springs)73 mg/L · 3 sites
Surface water (rivers, lakes)75 mg/L · 12 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Stevens County

Prefilled with Stevens County's measured local hardness of 73 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Stevens County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis County

Cities and communities in Stevens County

PlaceMedian mg/LClassBased on
Colville 73 Moderately hard county median
Chewelah 73 Moderately hard county median
Kettle Falls 73 Moderately hard county median
Loon Lake (CDP) 73 Moderately hard county median
Clayton (CDP) 73 Moderately hard county median
Northport 70 Moderately hard 9 sites within 10 miles
Springdale 73 Moderately hard county median
Addy (CDP) 73 Moderately hard county median
Marcus 73 Moderately hard county median
Valley (CDP) 73 Moderately hard county median
Suncrest (CDP) 73 Moderately hard county median

Water quality in Stevens County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Colville Colville Water Department None detected 0 lead · 1,861 unknown None
Kettle Falls Kettle Falls Water Dept Not tested Not reported None
Northport Northport Water System Not tested 0 lead · 0 unknown 1
Springdale Town of Springdale Not tested Not reported None
Marcus Marcus Water Dept Not tested 0 lead · 0 unknown None
Valley Valley Water System Not tested 0 lead · 545 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next