Water hardness in Okanogan County, WA

Water in Okanogan County is moderately hard, with a median of 94 mg/L (5.5 grains per gallon) across 76 monitoring sites.

27% harder than the Washington median (74 mg/L) 13th hardest of 35 counties
94mg/L
5.5 grains per gallon
Moderately hard

Okanogan County water at a glance

  • HardnessModerately hard (94 mg/L, 5.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 94 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.5 gpg (5.3 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites76
Lab samples855
Sample years2000–2024
Middle 50% of sites63–150 mg/L
Groundwater (wells, springs)125 mg/L · 48 sites
Surface water (rivers, lakes)65 mg/L · 28 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Okanogan County

Prefilled with Okanogan County's measured local hardness of 94 mg/L (5.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Okanogan County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Okanogan County

PlaceMedian mg/LClassBased on
Omak 216 Very hard 7 sites within 10 miles
Okanogan 218 Very hard 8 sites within 10 miles
Brewster 119 Moderately hard 3 sites within 10 miles
Oroville 93 Moderately hard 3 sites within 10 miles
Tonasket 94 Moderately hard county median
Twisp 92 Moderately hard 23 sites within 10 miles
North Omak (CDP) 230 Very hard 6 sites within 10 miles
Pateros 130 Hard 5 sites within 10 miles
Winthrop 84 Moderately hard 27 sites within 10 miles
Malott (CDP) 220 Very hard 3 sites within 10 miles
Riverside 230 Very hard 4 sites within 10 miles
Nespelem Community (CDP) 100 Moderately hard 14 sites within 10 miles
Elmer City 106 Moderately hard 12 sites within 10 miles
Conconully 94 Moderately hard county median
Nespelem 102 Moderately hard 13 sites within 10 miles
Loomis (CDP) 94 Moderately hard county median
Disautel (CDP) 120 Moderately hard 3 sites within 10 miles
Methow (CDP) 156 Hard 6 sites within 10 miles

Water quality in Okanogan County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Omak City of Omak 1 found 0 lead · 0 unknown None
Okanogan City of Okanogan Water Department Not tested 0 lead · 0 unknown None
Brewster City of Brewster Not tested 0 lead · 0 unknown None
Oroville City of Oroville Not tested 0 lead · 0 unknown None
Tonasket Tonasket Water System Not tested 0 lead · 0 unknown None
Twisp Town of Twisp Not tested 0 lead · 0 unknown None
Pateros Pateros Water Department Not tested Not reported None
Winthrop Town of Winthrop Not tested Not reported None
Riverside Town of Riverside Not tested 0 lead · 0 unknown None
Elmer City Elmer City Water System Not tested 0 lead · 0 unknown None
Nespelem Nespelem Water Dept Not tested 0 lead · 232 unknown None
Methow Methow Water System INC Not tested Not reported None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next