Water hardness in Island County, WA

Water in Island County is very hard, with a median of 289 mg/L (16.9 grains per gallon) across 1 monitoring site.

291% harder than the Washington median (74 mg/L) 1st hardest of 35 counties
289mg/L
16.9 grains per gallon
Very hard

Island County water at a glance

  • HardnessVery hard (289 mg/L, 16.9 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 289 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.9 gpg (16.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples1
Sample years2014–2014
Middle 50% of sites289–289 mg/L
Groundwater (wells, springs)289 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Island County

Prefilled with Island County's measured local hardness of 289 mg/L (16.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Island County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountyAdams CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Island County

PlaceMedian mg/LClassBased on
Oak Harbor 289 Very hard county median
Freeland (CDP) 289 Very hard county median
Coupeville 289 Very hard county median
Whidbey Island Station (CDP) 289 Very hard county median
Langley 289 Very hard county median
Clinton (CDP) 289 Very hard county median
Camano (CDP) 47 Soft 34 sites within 10 miles

Water quality in Island County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Oak Harbor City of Oak Harbor None detected 0 lead · 0 unknown None
Freeland Freeland Water and Sewer District Not tested 0 lead · 0 unknown None
Coupeville Town of Coupeville 7 found (PFOA 9.8 / PFOS ND ppt) 0 lead · 599 unknown None
Langley City of Langley Not tested 0 lead · 0 unknown 1
Clinton Clinton Water District Not tested 0 lead · 0 unknown None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next