Water hardness in Adams County, WA

Water in Adams County is very hard, with a median of 233 mg/L (13.6 grains per gallon) across 11 monitoring sites.

215% harder than the Washington median (74 mg/L) 3rd hardest of 35 counties
233mg/L
13.6 grains per gallon
Very hard

Adams County water at a glance

  • HardnessVery hard (233 mg/L, 13.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 233 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.6 gpg (13.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites11
Lab samples36
Sample years2000–2023
Middle 50% of sites104–253 mg/L
Groundwater (wells, springs)233 mg/L · 11 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Adams County

Prefilled with Adams County's measured local hardness of 233 mg/L (13.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Adams County on the Washington map

King CountyLincoln CountyPend Oreille CountyAsotin CountySkagit CountyFranklin CountyWhitman CountyYakima CountyClark CountyBenton CountyKittitas CountyWahkiakum CountyIsland CountyClallam CountyGrays Harbor CountyPacific CountySan Juan CountySpokane CountyWhatcom CountyDouglas CountyGrant CountySnohomish CountyOkanogan CountyFerry CountyCowlitz CountyMason CountyColumbia CountySkamania CountyJefferson CountyWalla Walla CountyPierce CountyChelan CountyGarfield CountyThurston CountyKlickitat CountyKitsap CountyLewis CountyStevens County

Cities and communities in Adams County

PlaceMedian mg/LClassBased on
Othello 232 Very hard 12 sites within 10 miles
Ritzville 233 Very hard county median
Lind 233 Very hard county median
Washtucna 233 Very hard county median
Hatton 233 Very hard county median

Water quality in Adams County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Othello Othello Water Department None detected 0 lead · 0 unknown None
Ritzville Ritzville Water Department Not tested 0 lead · 547 unknown None
Lind Town of Lind Not tested 0 lead · 0 unknown None
Washtucna Washtucna Water Department Not tested Not reported None
Hatton Town of Hatton Not tested Not reported None

Neighboring counties

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next