Water hardness in Mason County, WA
Water in Mason County is soft, with a median of 40 mg/L (2.3 grains per gallon) across 44 monitoring sites.
Mason County water at a glance
- HardnessSoft (40 mg/L, 2.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 40 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.3 gpg (2.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mason County
Prefilled with Mason County's measured local hardness of 40 mg/L (2.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Mason County on the Washington map
Cities and communities in Mason County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Shelton | 33 | Soft | 9 sites within 10 miles |
| Belfair (CDP) | 38 | Soft | 34 sites within 10 miles |
| Allyn (CDP) | 41 | Soft | 29 sites within 10 miles |
| Grapeview (CDP) | 42 | Soft | 23 sites within 10 miles |
| Union (CDP) | 37 | Soft | 30 sites within 10 miles |
| Skokomish (CDP) | 37 | Soft | 20 sites within 10 miles |
| Hoodsport (CDP) | 34 | Soft | 24 sites within 10 miles |
Water quality in Mason County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Shelton | City of Shelton | None detected | 0 lead · 2,881 unknown | None |
| Union | Union | Not tested | 0 lead · 0 unknown | None |
| Hoodsport | Hoodsport | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Kitsap County88 mg/L
- Thurston County58 mg/L
- Jefferson County25 mg/L
- Pierce County51 mg/L
- Island County289 mg/L
- Pacific County16 mg/L
Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.