Water hardness in Wilkes County, NC
Water in Wilkes County is soft, with a median of 12 mg/L (0.7 grains per gallon) across 11 monitoring sites.
Wilkes County water at a glance
- HardnessSoft (12 mg/L, 0.7 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 12 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.7 gpg (0.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wilkes County
Prefilled with Wilkes County's measured local hardness of 12 mg/L (0.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wilkes County on the North Carolina map
Cities and communities in Wilkes County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| North Wilkesboro | 11 | Soft | 8 sites within 10 miles |
| Wilkesboro | 12 | Soft | 5 sites within 10 miles |
| Mulberry (CDP) | 11 | Soft | 7 sites within 10 miles |
| Fairplains (CDP) | 11 | Soft | 8 sites within 10 miles |
| Millers Creek (CDP) | 12 | Soft | 5 sites within 10 miles |
| Moravian Falls (CDP) | 12 | Soft | 5 sites within 10 miles |
| Cricket (CDP) | 12 | Soft | 5 sites within 10 miles |
| Hays (CDP) | 12 | Soft | 5 sites within 10 miles |
| Pleasant Hill (CDP) | 15 | Soft | 6 sites within 10 miles |
| Ronda | 15 | Soft | 6 sites within 10 miles |
Water quality in Wilkes County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| North Wilkesboro | Town of North Wilkesboro | None detected | 0 lead · 64 unknown | None |
| Wilkesboro | Town of Wilkesboro | None detected | 0 lead · 1,651 unknown | None |
| Moravian Falls | Moravian Falls Water System | None detected | 0 lead · 0 unknown | 1 |
| Hays | Blue Ridge Water Association | 1 found | Not reported | 1 |
| Ronda | Town of Ronda | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Alleghany County18 mg/L
- Alexander County17 mg/L
- Ashe County20 mg/L
- Caldwell County12 mg/L
- Yadkin County55 mg/L
- Surry County22 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.