Water hardness in Wake County, NC
Water in Wake County is soft, with a median of 30 mg/L (1.8 grains per gallon) across 99 monitoring sites.
Wake County water at a glance
- HardnessSoft (30 mg/L, 1.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 30 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.8 gpg (1.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wake County
Prefilled with Wake County's measured local hardness of 30 mg/L (1.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wake County on the North Carolina map
Cities and communities in Wake County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Raleigh | 30 | Soft | 57 sites within 10 miles |
| Cary | 30 | Soft | 45 sites within 10 miles |
| Apex | 30 | Soft | 16 sites within 10 miles |
| Wake Forest | 26 | Soft | 16 sites within 10 miles |
| Holly Springs | 24 | Soft | 14 sites within 10 miles |
| Fuquay-Varina | 24 | Soft | 14 sites within 10 miles |
| Garner | 34 | Soft | 70 sites within 10 miles |
| Morrisville | 37 | Soft | 30 sites within 10 miles |
| Knightdale | 53 | Soft | 40 sites within 10 miles |
| Wendell | 98 | Moderately hard | 25 sites within 10 miles |
| Rolesville | 26 | Soft | 14 sites within 10 miles |
| Zebulon | 24 | Soft | 5 sites within 10 miles |
Water quality in Wake County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Raleigh | City of Raleigh | 5 found (PFOA ND / PFOS 5.6 ppt) | 0 lead · 10,366 unknown | None |
| Cary | Town of Cary | 4 found | 0 lead · 0 unknown | 1 |
| Apex | Town of Apex | 4 found | 0 lead · 0 unknown | None |
| Wake Forest | New Light Master | Not tested | 0 lead · 25 unknown | None |
| Holly Springs | Town of Holly Springs | 8 found (PFOA 5.9 / PFOS 12 ppt) | 0 lead · 0 unknown | None |
| Fuquay-Varina | Town of Fuquay-Varina | 9 found (PFOA 11 / PFOS 11 ppt) | 0 lead · 0 unknown | 1 |
| Garner | Garner Estates MH S/D | Not tested | 0 lead · 26 unknown | None |
| Knightdale | Oak Grove of Knightdale | Not tested | 0 lead · 0 unknown | None |
| Wendell | Gaylee Village | Not tested | 0 lead · 150 unknown | None |
| Rolesville | Lakes of Rolesville S/D | Not tested | 0 lead · 0 unknown | None |
| Zebulon | Buffalo Creek S/D | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Durham County36 mg/L
- Johnston County26 mg/L
- Franklin County25 mg/L
- Harnett County31 mg/L
- Orange County32 mg/L
- Chatham County38 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.