Water hardness in Anson County, NC
Water in Anson County is soft, with a median of 27 mg/L (1.6 grains per gallon) across 7 monitoring sites.
Anson County water at a glance
- HardnessSoft (27 mg/L, 1.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 27 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.6 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Anson County
Prefilled with Anson County's measured local hardness of 27 mg/L (1.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Anson County on the North Carolina map
Cities and communities in Anson County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Wadesboro | 28 | Soft | 7 sites within 10 miles |
| Polkton | 38 | Soft | 4 sites within 10 miles |
| Ansonville | 33 | Soft | 9 sites within 10 miles |
| Lilesville | 27 | Soft | 12 sites within 10 miles |
| Peachland | 87 | Moderately hard | 3 sites within 10 miles |
| Morven | 24 | Soft | 6 sites within 10 miles |
| McFarlan | 22 | Soft | 4 sites within 10 miles |
Water quality in Anson County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Wadesboro | Town of Wadesboro | 4 found (PFOA ND / PFOS 5.2 ppt) | 0 lead · 2,311 unknown | None |
| Polkton | Polkton Water System | Not tested | 0 lead · 0 unknown | None |
| Ansonville | Ansonville Water System | Not tested | 0 lead · 0 unknown | None |
| Lilesville | Lilesville Water System | Not tested | 0 lead · 11 unknown | 2 |
| Peachland | Peachland Water System | Not tested | 4 lead · 1 unknown | None |
| Morven | Morven Water System | Not tested | 1 lead · 406 unknown | 1 |
Neighboring counties
- Richmond County12 mg/L
- Union County49 mg/L
- Stanly County46 mg/L
- Montgomery County23 mg/L
- Scotland County26 mg/L
- Cabarrus County69 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.