Water hardness in Surry County, NC
Water in Surry County is soft, with a median of 22 mg/L (1.3 grains per gallon) across 6 monitoring sites.
Surry County water at a glance
- HardnessSoft (22 mg/L, 1.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 22 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.3 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Surry County
Prefilled with Surry County's measured local hardness of 22 mg/L (1.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Surry County on the North Carolina map
Cities and communities in Surry County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Mount Airy | 22 | Soft | county median |
| Elkin | 20 | Soft | 5 sites within 10 miles |
| Flat Rock (CDP) | 22 | Soft | county median |
| Dobson | 22 | Soft | county median |
| Toast (CDP) | 22 | Soft | county median |
| Pilot Mountain | 31 | Soft | 5 sites within 10 miles |
| White Plains (CDP) | 22 | Soft | county median |
| Lowgap (CDP) | 16 | Soft | 4 sites within 10 miles |
Water quality in Surry County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Mount Airy | City of Mount Airy | None detected | 0 lead · 3,011 unknown | None |
| Elkin | Town of Elkin | None detected | 0 lead · 1,824 unknown | None |
| Flat Rock | Cinnamon Woods | Not tested | 0 lead · 0 unknown | 1 |
| Dobson | Town of Dobson | Not tested | 0 lead · 336 unknown | 1 |
| Pilot Mountain | Pilot Mountain MHP | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Yadkin County55 mg/L
- Stokes County20 mg/L
- Alleghany County18 mg/L
- Wilkes County12 mg/L
- Forsyth County36 mg/L
- Davie County46 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.