Water hardness in Beaufort County, NC
Water in Beaufort County is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 19 monitoring sites.
Beaufort County water at a glance
- HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 106 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Beaufort County
Prefilled with Beaufort County's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Beaufort County on the North Carolina map
Cities and communities in Beaufort County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Washington | 43 | Soft | 20 sites within 10 miles |
| River Road (CDP) | 67 | Moderately hard | 9 sites within 10 miles |
| Belhaven | 80 | Moderately hard | 4 sites within 10 miles |
| Chocowinity | 62 | Moderately hard | 22 sites within 10 miles |
| Aurora | 121 | Hard | 3 sites within 10 miles |
| Washington Park | 46 | Soft | 16 sites within 10 miles |
| Bayview (CDP) | 106 | Moderately hard | county median |
| Bath | 210 | Very hard | 5 sites within 10 miles |
| Pantego | 102 | Moderately hard | 5 sites within 10 miles |
| Pinetown (CDP) | 102 | Moderately hard | 5 sites within 10 miles |
| Cypress Landing (CDP) | 62 | Moderately hard | 20 sites within 10 miles |
Water quality in Beaufort County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Washington | City of Washington | None detected | 4 lead · 2,597 unknown | 1 |
| Belhaven | Belhaven Water System | Not tested | 0 lead · 0 unknown | None |
| Chocowinity | Chocowinity Water System | Not tested | 13 lead · 2 unknown | 1 |
| Aurora | Aurora Water System | Not tested | 0 lead · 0 unknown | 8 |
| Bath | Bath Water System | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Pamlico County273 mg/L
- Craven County110 mg/L
- Washington County142 mg/L
- Martin County45 mg/L
- Pitt County37 mg/L
- Hyde County220 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.