Water hardness in Martin County, NC
Water in Martin County is soft, with a median of 45 mg/L (2.6 grains per gallon) across 9 monitoring sites.
Martin County water at a glance
- HardnessSoft (45 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 45 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Martin County
Prefilled with Martin County's measured local hardness of 45 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Martin County on the North Carolina map
Cities and communities in Martin County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Williamston | 42 | Soft | 6 sites within 10 miles |
| Robersonville | 51 | Soft | 4 sites within 10 miles |
| Jamesville | 37 | Soft | 12 sites within 10 miles |
| Hamilton | 39 | Soft | 7 sites within 10 miles |
| Oak City | 37 | Soft | 6 sites within 10 miles |
| Parmele | 48 | Soft | 6 sites within 10 miles |
| Everetts | 39 | Soft | 6 sites within 10 miles |
| Bear Grass | 32 | Soft | 9 sites within 10 miles |
| Hassell | 41 | Soft | 8 sites within 10 miles |
Water quality in Martin County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Williamston | Town of Williamston | 1 found (PFOA ND / PFOS 4.8 ppt) | 3 lead · 1,614 unknown | 1 |
| Robersonville | Town of Robersonville | Not tested | 1 lead · 100 unknown | 1 |
| Jamesville | Town of Jamesville | Not tested | 0 lead · 0 unknown | None |
| Hamilton | Town of Hamilton | Not tested | 0 lead · 0 unknown | None |
| Parmele | Town of Parmele | Not tested | 0 lead · 0 unknown | None |
| Everetts | Town of Everetts | Not tested | 2 lead · 5 unknown | None |
Neighboring counties
- Bertie County33 mg/L
- Pitt County37 mg/L
- Edgecombe County29 mg/L
- Beaufort County106 mg/L
- Washington County142 mg/L
- Chowan County30 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.