Water hardness in Bladen County, NC
Water in Bladen County is soft, with a median of 22 mg/L (1.3 grains per gallon) across 29 monitoring sites.
Bladen County water at a glance
- HardnessSoft (22 mg/L, 1.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 22 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.3 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Bladen County
Prefilled with Bladen County's measured local hardness of 22 mg/L (1.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Bladen County on the North Carolina map
Cities and communities in Bladen County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Elizabethtown | 19 | Soft | 16 sites within 10 miles |
| Bladenboro | 17 | Soft | 8 sites within 10 miles |
| White Lake | 21 | Soft | 14 sites within 10 miles |
| Clarkton | 24 | Soft | 8 sites within 10 miles |
| Kelly (CDP) | 25 | Soft | 5 sites within 10 miles |
| East Arcadia | 27 | Soft | 8 sites within 10 miles |
| White Oak (CDP) | 19 | Soft | 9 sites within 10 miles |
| Butters (CDP) | 16 | Soft | 6 sites within 10 miles |
| Dublin | 20 | Soft | 12 sites within 10 miles |
| Tar Heel | 26 | Soft | 6 sites within 10 miles |
Water quality in Bladen County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Elizabethtown | Town of Elizabethtown | 1 found | 0 lead · 907 unknown | None |
| Bladenboro | Town of Bladenboro | Not tested | 0 lead · 0 unknown | 1 |
| White Lake | Town of White Lake | None detected | 0 lead · 0 unknown | 1 |
| Clarkton | Town of Clarkton | None detected | 0 lead · 0 unknown | None |
| East Arcadia | Town of East Arcadia | Not tested | 0 lead · 193 unknown | 2 |
| White Oak | White Oak Village | Not tested | 0 lead · 0 unknown | 1 |
| Dublin | Town of Dublin | Not tested | 0 lead · 68 unknown | 1 |
Neighboring counties
- Columbus County21 mg/L
- Sampson County32 mg/L
- Robeson County18 mg/L
- Cumberland County12 mg/L
- Pender County55 mg/L
- Duplin County45 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.