Water hardness in Johnston County, NC
Water in Johnston County is soft, with a median of 26 mg/L (1.5 grains per gallon) across 18 monitoring sites.
Johnston County water at a glance
- HardnessSoft (26 mg/L, 1.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 26 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.5 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Johnston County
Prefilled with Johnston County's measured local hardness of 26 mg/L (1.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Johnston County on the North Carolina map
Cities and communities in Johnston County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Clayton | 78 | Moderately hard | 26 sites within 10 miles |
| Smithfield | 30 | Soft | 8 sites within 10 miles |
| Selma | 25 | Soft | 9 sites within 10 miles |
| Archer Lodge | 99 | Moderately hard | 24 sites within 10 miles |
| Benson | 29 | Soft | 4 sites within 10 miles |
| Wilson's Mills | 30 | Soft | 7 sites within 10 miles |
| Four Oaks | 30 | Soft | 5 sites within 10 miles |
| Pine Level | 22 | Soft | 7 sites within 10 miles |
| Princeton | 19 | Soft | 7 sites within 10 miles |
| Micro | 22 | Soft | 7 sites within 10 miles |
Water quality in Johnston County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Clayton | Town of Clayton | 5 found (PFOA 8.2 / PFOS 8.1 ppt) | 0 lead · 0 unknown | None |
| Smithfield | Town of Smithfield NC | 6 found (PFOA 4.7 / PFOS 7.7 ppt) | 1 lead · 5,554 unknown | 1 |
| Selma | Town of Selma | 7 found (PFOA ND / PFOS 11 ppt) | 0 lead · 2,346 unknown | 1 |
| Benson | Town of Benson | 8 found (PFOA 8.9 / PFOS 15 ppt) | 0 lead · 941 unknown | None |
| Four Oaks | Town of Four Oaks | Not tested | 0 lead · 0 unknown | 7 |
| Pine Level | Town of Pine Level | Not tested | 0 lead · 748 unknown | 1 |
| Princeton | Town of Princeton | Not tested | 0 lead · 0 unknown | 6 |
| Micro | Town of Micro | Not tested | 0 lead · 364 unknown | None |
Neighboring counties
- Wayne County26 mg/L
- Wake County30 mg/L
- Wilson County23 mg/L
- Harnett County31 mg/L
- Sampson County32 mg/L
- Nash County24 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.