Water hardness in Haywood County, NC
Water in Haywood County is soft, with a median of 9 mg/L (0.5 grains per gallon) across 24 monitoring sites.
Haywood County water at a glance
- HardnessSoft (9 mg/L, 0.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 9 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.5 gpg (0.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Haywood County
Prefilled with Haywood County's measured local hardness of 9 mg/L (0.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Haywood County on the North Carolina map
Cities and communities in Haywood County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Waynesville | 10 | Soft | 13 sites within 10 miles |
| Canton | 14 | Soft | 11 sites within 10 miles |
| Lake Junaluska (CDP) | 14 | Soft | 15 sites within 10 miles |
| Maggie Valley | 12 | Soft | 12 sites within 10 miles |
| Clyde | 10 | Soft | 14 sites within 10 miles |
| West Canton (CDP) | 14 | Soft | 11 sites within 10 miles |
Water quality in Haywood County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Waynesville | Town of Waynesville | None detected | 5 lead · 6,047 unknown | 1 |
| Canton | Town of Canton | None detected | 0 lead · 3,266 unknown | None |
| Lake Junaluska | Lake Junaluska Assembly | Not tested | 0 lead · 0 unknown | 1 |
| Maggie Valley | Maggie Valley Sanitary Dist | None detected | 0 lead · 3,203 unknown | 1 |
| Clyde | Town of Clyde | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Jackson County5 mg/L
- Buncombe County13 mg/L
- Transylvania County5 mg/L
- Madison County10 mg/L
- Swain County6 mg/L
- Henderson County11 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.