Water hardness in Pitt County, NC
Water in Pitt County is soft, with a median of 37 mg/L (2.1 grains per gallon) across 42 monitoring sites.
Pitt County water at a glance
- HardnessSoft (37 mg/L, 2.1 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 37 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.1 gpg (2.1 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Pitt County
Prefilled with Pitt County's measured local hardness of 37 mg/L (2.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Pitt County on the North Carolina map
Cities and communities in Pitt County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Greenville | 30 | Soft | 15 sites within 10 miles |
| Winterville | 50 | Soft | 102 sites within 10 miles |
| Ayden | 48 | Soft | 107 sites within 10 miles |
| Farmville | 46 | Soft | 120 sites within 10 miles |
| Bethel | 48 | Soft | 8 sites within 10 miles |
| Bell Arthur (CDP) | 46 | Soft | 122 sites within 10 miles |
| Simpson | 31 | Soft | 17 sites within 10 miles |
| Grimesland | 34 | Soft | 21 sites within 10 miles |
| Fountain | 39 | Soft | 27 sites within 10 miles |
| Stokes (CDP) | 28 | Soft | 4 sites within 10 miles |
| Belvoir (CDP) | 38 | Soft | 13 sites within 10 miles |
| Falkland | 38 | Soft | 19 sites within 10 miles |
Water quality in Pitt County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Greenville | Greenville Utilities Comm | 6 found (PFOA 7.6 / PFOS 6.3 ppt) | 0 lead · 0 unknown | None |
| Winterville | Town of Winterville | 5 found (PFOA 5.3 / PFOS 6.6 ppt) | 0 lead · 1,366 unknown | 1 |
| Ayden | Town of Ayden | 7 found (PFOA 6.5 / PFOS 11.5 ppt) | 0 lead · 1,785 unknown | None |
| Farmville | Town of Farmville | 5 found (PFOA 5.3 / PFOS 4.2 ppt) | 0 lead · 3,816 unknown | None |
| Bethel | Town of Bethel | Not tested | 0 lead · 0 unknown | None |
| Bell Arthur | Bell Arthur Water Corp | 7 found (PFOA 4.4 / PFOS 9.9 ppt) | 0 lead · 0 unknown | 1 |
| Grimesland | Town of Grimesland | Not tested | 0 lead · 0 unknown | None |
| Fountain | Town of Fountain | Not tested | 0 lead · 108 unknown | 1 |
| Stokes | Stokes Regional Water Corp | 5 found (PFOA 5.8 / PFOS 6 ppt) | 0 lead · 0 unknown | 2 |
Neighboring counties
- Greene County52 mg/L
- Martin County45 mg/L
- Edgecombe County29 mg/L
- Lenoir County35 mg/L
- Beaufort County106 mg/L
- Wilson County23 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.