Water hardness in Greene County, NC
Water in Greene County is soft, with a median of 52 mg/L (3 grains per gallon) across 108 monitoring sites.
Greene County water at a glance
- HardnessSoft (52 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 52 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Greene County
Prefilled with Greene County's measured local hardness of 52 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Greene County on the North Carolina map
Cities and communities in Greene County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Maury (CDP) | 46 | Soft | 123 sites within 10 miles |
| Snow Hill | 50 | Soft | 117 sites within 10 miles |
| Hookerton | 46 | Soft | 119 sites within 10 miles |
| Walstonburg | 49 | Soft | 114 sites within 10 miles |
Water quality in Greene County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Maury | Maury Water Association | Not tested | Not reported | 1 |
| Snow Hill | Town of Snow Hill | Not tested | 1 lead · 58 unknown | None |
| Hookerton | Town of Hookerton | Not tested | 0 lead · 1 unknown | None |
| Walstonburg | Town of Walstonburg | Not tested | 1 lead · 0 unknown | 1 |
Neighboring counties
- Lenoir County35 mg/L
- Pitt County37 mg/L
- Wilson County23 mg/L
- Wayne County26 mg/L
- Edgecombe County29 mg/L
- Jones County110 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.