Water hardness in Buncombe County, NC
Water in Buncombe County is soft, with a median of 13 mg/L (0.8 grains per gallon) across 35 monitoring sites.
Buncombe County water at a glance
- HardnessSoft (13 mg/L, 0.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 13 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.8 gpg (0.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Buncombe County
Prefilled with Buncombe County's measured local hardness of 13 mg/L (0.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Buncombe County on the North Carolina map
Cities and communities in Buncombe County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Asheville | 11 | Soft | 29 sites within 10 miles |
| Black Mountain | 9 | Soft | 4 sites within 10 miles |
| Woodfin | 22 | Soft | 11 sites within 10 miles |
| Weaverville | 16 | Soft | 12 sites within 10 miles |
| Swannanoa (CDP) | 13 | Soft | 6 sites within 10 miles |
| Royal Pines (CDP) | 12 | Soft | 32 sites within 10 miles |
| Fairview (CDP) | 13 | Soft | 8 sites within 10 miles |
| Avery Creek (CDP) | 12 | Soft | 32 sites within 10 miles |
| Biltmore Forest | 9 | Soft | 30 sites within 10 miles |
| Bent Creek (CDP) | 9 | Soft | 30 sites within 10 miles |
| Montreat | 13 | Soft | 5 sites within 10 miles |
| Barnardsville (CDP) | 13 | Soft | county median |
| Emma (CDP) | 13 | Soft | 28 sites within 10 miles |
Water quality in Buncombe County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Asheville | City of Asheville | None detected | 2 lead · 42,588 unknown | 1 |
| Black Mountain | Town of Black Mountain | Not tested | 0 lead · 2,988 unknown | 1 |
| Weaverville | Town of Weaverville | None detected | 0 lead · 737 unknown | None |
| Fairview | Twin Creeks S/D | Not tested | 0 lead · 3 unknown | None |
| Biltmore Forest | Town of Biltmore Forest | Not tested | 0 lead · 0 unknown | 1 |
| Bent Creek | Bent Creek Water System | Not tested | 0 lead · 298 unknown | None |
| Montreat | Montreat Water System | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Henderson County11 mg/L
- Madison County10 mg/L
- Yancey County5 mg/L
- Haywood County9 mg/L
- McDowell County24 mg/L
- Polk County11 mg/L
North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.