Water hardness in Harford County, MD

Water in Harford County is moderately hard, with a median of 75 mg/L (4.4 grains per gallon) across 65 monitoring sites.

34% harder than the Maryland median (56 mg/L) 10th hardest of 24 counties
75mg/L
4.4 grains per gallon
Moderately hard

Harford County water at a glance

  • HardnessModerately hard (75 mg/L, 4.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 75 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.4 gpg (4.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites65
Lab samples419
Sample years2000–2023
Middle 50% of sites48–119 mg/L
Groundwater (wells, springs)74 mg/L · 57 sites
Surface water (rivers, lakes)78 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Harford County

Prefilled with Harford County's measured local hardness of 75 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Harford County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Harford County

PlaceMedian mg/LClassBased on
Bel Air South (CDP) 88 Moderately hard 48 sites within 10 miles
Bel Air North (CDP) 76 Moderately hard 53 sites within 10 miles
Edgewood (CDP) 83 Moderately hard 32 sites within 10 miles
Aberdeen 93 Moderately hard 30 sites within 10 miles
Havre de Grace 76 Moderately hard 30 sites within 10 miles
Joppatowne (CDP) 92 Moderately hard 37 sites within 10 miles
Bel Air 78 Moderately hard 53 sites within 10 miles
Fallston (CDP) 71 Moderately hard 61 sites within 10 miles
Riverside (CDP) 83 Moderately hard 41 sites within 10 miles
Pleasant Hills (CDP) 83 Moderately hard 64 sites within 10 miles
Jarrettsville (CDP) 57 Soft 56 sites within 10 miles
Perryman (CDP) 78 Moderately hard 29 sites within 10 miles
Aberdeen Proving Ground (CDP) 75 Moderately hard 19 sites within 10 miles
Pylesville (CDP) 56 Soft 24 sites within 10 miles
Darlington (CDP) 91 Moderately hard 31 sites within 10 miles
Abingdon (CDP) 83 Moderately hard 38 sites within 10 miles

Water quality in Harford County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Aberdeen City of Aberdeen 8 found (PFOA 7.6 / PFOS 8.6 ppt) 0 lead · 2,698 unknown None
Havre de Grace City of Havre De Grace None detected 0 lead · 2,603 unknown 5
Darlington Town of Darlington Not tested 0 lead · 26 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next