Water hardness in St. Mary's County, MD

Water in St. Mary's County is soft, with a median of 8 mg/L (0.5 grains per gallon) across 26 monitoring sites.

86% softer than the Maryland median (56 mg/L) 23rd hardest of 24 counties
8mg/L
0.5 grains per gallon
Soft

St. Mary's County water at a glance

  • HardnessSoft (8 mg/L, 0.5 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 8 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.5 gpg (0.4 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites26
Lab samples29
Sample years2000–2022
Middle 50% of sites2–14 mg/L
Groundwater (wells, springs)8 mg/L · 24 sites
Surface water (rivers, lakes)31 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for St. Mary's County

Prefilled with St. Mary's County's measured local hardness of 8 mg/L (0.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

St. Mary's County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in St. Mary's County

PlaceMedian mg/LClassBased on
California (CDP) 12 Soft 23 sites within 10 miles
Lexington Park (CDP) 8 Soft 22 sites within 10 miles
Leonardtown 3 Soft 14 sites within 10 miles
Golden Beach (CDP) 29 Soft 7 sites within 10 miles
Mechanicsville (CDP) 17 Soft 6 sites within 10 miles
Charlotte Hall (CDP) 18 Soft 9 sites within 10 miles
Piney Point (CDP) 11 Soft 9 sites within 10 miles
Tall Timbers (CDP) 4 Soft 17 sites within 10 miles
St. George Island (CDP) 11 Soft 7 sites within 10 miles
Callaway (CDP) 11 Soft 24 sites within 10 miles
Wildewood (CDP) 12 Soft 24 sites within 10 miles

Water quality in St. Mary's County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Lexington Park Lexington Park None detected 0 lead · 38 unknown None
Leonardtown Town of Leonardtown Not tested 0 lead · 0 unknown 1
Charlotte Hall Charlotte Hall Not tested 0 lead · 0 unknown None
Piney Point Piney Point None detected 0 lead · 0 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next