Water hardness in Cecil County, MD
Water in Cecil County is soft, with a median of 54 mg/L (3.2 grains per gallon) across 24 monitoring sites.
Cecil County water at a glance
- HardnessSoft (54 mg/L, 3.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 54 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.2 gpg (3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Cecil County
Prefilled with Cecil County's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Cecil County on the Maryland map
Cities and communities in Cecil County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Elkton | 14 | Soft | 11 sites within 10 miles |
| Perryville | 70 | Moderately hard | 25 sites within 10 miles |
| North East | 19 | Soft | 15 sites within 10 miles |
| Rising Sun | 83 | Moderately hard | 18 sites within 10 miles |
| Charlestown | 32 | Soft | 20 sites within 10 miles |
| Chesapeake City | 14 | Soft | 10 sites within 10 miles |
| Cecilton | 61 | Moderately hard | 27 sites within 10 miles |
| Port Deposit | 78 | Moderately hard | 29 sites within 10 miles |
Water quality in Cecil County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Elkton | Town of Elkton | 8 found (PFOA 23.3 / PFOS 7.1 ppt) | 0 lead · 295 unknown | 2 |
| Perryville | Town of Perryville | None detected | 0 lead · 595 unknown | 12 |
| North East | Town of North East | 1 found | 0 lead · 444 unknown | 13 |
| Rising Sun | Town of Rising Sun | Not tested | 0 lead · 930 unknown | 1 |
| Charlestown | Town of Charlestown | Not tested | 0 lead · 0 unknown | 1 |
| Cecilton | Town of Cecilton | Not tested | 0 lead · 34 unknown | 3 |
| Port Deposit | Port Deposit | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Harford County75 mg/L
- Kent County58 mg/L
- Queen Anne's County61 mg/L
- Baltimore County154 mg/L
- Baltimore city266 mg/L
- Caroline County38 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.