Water hardness in Charles County, MD

Water in Charles County is soft, with a median of 24 mg/L (1.4 grains per gallon) across 43 monitoring sites.

57% softer than the Maryland median (56 mg/L) 22nd hardest of 24 counties
24mg/L
1.4 grains per gallon
Soft

Charles County water at a glance

  • HardnessSoft (24 mg/L, 1.4 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 24 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites43
Lab samples63
Sample years2000–2022
Middle 50% of sites12–52 mg/L
Groundwater (wells, springs)15 mg/L · 21 sites
Surface water (rivers, lakes)28 mg/L · 22 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Charles County

Prefilled with Charles County's measured local hardness of 24 mg/L (1.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Charles County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Charles County

PlaceMedian mg/LClassBased on
Waldorf (CDP) 29 Soft 34 sites within 10 miles
La Plata 29 Soft 33 sites within 10 miles
Bryans Road (CDP) 30 Soft 28 sites within 10 miles
Indian Head 30 Soft 24 sites within 10 miles
Hughesville (CDP) 13 Soft 14 sites within 10 miles
Cobb Island (CDP) 18 Soft 4 sites within 10 miles
Potomac Heights (CDP) 34 Soft 26 sites within 10 miles
Bryantown (CDP) 29 Soft 20 sites within 10 miles
Pomfret (CDP) 29 Soft 29 sites within 10 miles
Benedict (CDP) 51 Soft 10 sites within 10 miles
Rock Point (CDP) 2 Soft 5 sites within 10 miles
Port Tobacco Village 36 Soft 29 sites within 10 miles
Bensville (CDP) 29 Soft 33 sites within 10 miles

Water quality in Charles County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Waldorf Waldorf - Charles County DPW 3 found 0 lead · 3,737 unknown None
La Plata Town of La Plata None detected 0 lead · 367 unknown None
Bryans Road Bryans Road None detected 0 lead · 543 unknown None
Indian Head Town of Indian Head None detected 2 lead · 629 unknown None
Potomac Heights Potomac Heights Not tested 0 lead · 12 unknown None
Benedict Benedict Not tested 0 lead · 30 unknown None

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next