Water hardness in Somerset County, MD

Water in Somerset County is soft, with a median of 34 mg/L (2 grains per gallon) across 8 monitoring sites.

39% softer than the Maryland median (56 mg/L) 20th hardest of 24 counties
34mg/L
2 grains per gallon
Soft

Somerset County water at a glance

  • HardnessSoft (34 mg/L, 2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 34 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2 gpg (1.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples16
Sample years2000–2023
Middle 50% of sites17–53 mg/L
Groundwater (wells, springs)46 mg/L · 6 sites
Surface water (rivers, lakes)23 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Somerset County

Prefilled with Somerset County's measured local hardness of 34 mg/L (2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Somerset County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Somerset County

PlaceMedian mg/LClassBased on
Princess Anne 27 Soft 7 sites within 10 miles
Crisfield 34 Soft county median
Eden (CDP) 27 Soft 11 sites within 10 miles
Mount Vernon (CDP) 27 Soft 7 sites within 10 miles
Deal Island (CDP) 34 Soft county median
Fairmount (CDP) 34 Soft county median
West Pocomoke (CDP) 50 Soft 20 sites within 10 miles
Chance (CDP) 34 Soft county median
Smith Island (CDP) 34 Soft county median
Dames Quarter (CDP) 34 Soft county median
Frenchtown-Rumbly (CDP) 34 Soft county median

Water quality in Somerset County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Princess Anne Town of Princess Anne None detected 0 lead · 564 unknown 1
Crisfield City of Crisfield Not tested 0 lead · 0 unknown None
Fairmount Fairmount Not tested 0 lead · 0 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next