Water hardness in Wicomico County, MD

Water in Wicomico County is soft, with a median of 30 mg/L (1.7 grains per gallon) across 20 monitoring sites.

46% softer than the Maryland median (56 mg/L) 21st hardest of 24 counties
30mg/L
1.7 grains per gallon
Soft

Wicomico County water at a glance

  • HardnessSoft (30 mg/L, 1.7 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 30 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.7 gpg (1.7 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites20
Lab samples27
Sample years2000–2023
Middle 50% of sites14–41 mg/L
Groundwater (wells, springs)23 mg/L · 17 sites
Surface water (rivers, lakes)31 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Wicomico County

Prefilled with Wicomico County's measured local hardness of 30 mg/L (1.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Wicomico County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Wicomico County

PlaceMedian mg/LClassBased on
Salisbury 11 Soft 9 sites within 10 miles
Fruitland 15 Soft 14 sites within 10 miles
Delmar 27 Soft 14 sites within 10 miles
Pittsville 28 Soft 23 sites within 10 miles
Hebron 28 Soft 8 sites within 10 miles
Willards 31 Soft 26 sites within 10 miles
Sharptown 44 Soft 8 sites within 10 miles
Mardela Springs 39 Soft 9 sites within 10 miles
Parsonsburg (CDP) 29 Soft 24 sites within 10 miles
Tyaskin (CDP) 30 Soft county median
Nanticoke (CDP) 30 Soft county median
Allen (CDP) 23 Soft 10 sites within 10 miles
Bivalve (CDP) 30 Soft county median
Powellville (CDP) 29 Soft 35 sites within 10 miles
Jesterville (CDP) 30 Soft county median
Quantico (CDP) 19 Soft 7 sites within 10 miles
Nanticoke Acres (CDP) 30 Soft county median
Whitehaven (CDP) 23 Soft 6 sites within 10 miles
Waterview (CDP) 30 Soft county median

Water quality in Wicomico County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Salisbury City of Salisbury 6 found (PFOA 5.9 / PFOS 20 ppt) 0 lead · 7,521 unknown None
Fruitland City of Fruitland 2 found (PFOA ND / PFOS 4.1 ppt) 0 lead · 1,000 unknown None
Delmar Town of Delmar None detected 3 lead · 481 unknown None
Pittsville Town of Pittsville Not tested 0 lead · 211 unknown 1
Hebron Town of Hebron Not tested 0 lead · 326 unknown None
Willards Town of Willards Not tested 0 lead · 161 unknown None
Sharptown Town of Sharptown Not tested 0 lead · 342 unknown 2

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next