Water hardness in Queen Anne's County, MD

Water in Queen Anne's County is moderately hard, with a median of 61 mg/L (3.6 grains per gallon) across 66 monitoring sites.

about the same as the Maryland median (56 mg/L) 12th hardest of 24 counties
61mg/L
3.6 grains per gallon
Moderately hard

Queen Anne's County water at a glance

  • HardnessModerately hard (61 mg/L, 3.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 61 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.6 gpg (3.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites66
Lab samples250
Sample years2000–2023
Middle 50% of sites44–71 mg/L
Groundwater (wells, springs)65 mg/L · 47 sites
Surface water (rivers, lakes)54 mg/L · 19 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Queen Anne's County

Prefilled with Queen Anne's County's measured local hardness of 61 mg/L (3.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Queen Anne's County on the Maryland map

Washington CountyAllegany CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyWorcester CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Queen Anne's County

PlaceMedian mg/LClassBased on
Stevensville (CDP) 50 Soft 12 sites within 10 miles
Centreville 64 Moderately hard 13 sites within 10 miles
Chester (CDP) 51 Soft 12 sites within 10 miles
Grasonville (CDP) 69 Moderately hard 10 sites within 10 miles
Kingstown (CDP) 57 Soft 94 sites within 10 miles
Church Hill 56 Soft 81 sites within 10 miles
Queenstown 62 Moderately hard 10 sites within 10 miles
Kent Narrows (CDP) 53 Soft 11 sites within 10 miles
Sudlersville 61 Moderately hard 70 sites within 10 miles
Queen Anne 44 Soft 27 sites within 10 miles
Barclay 59 Soft 64 sites within 10 miles
Templeville 61 Moderately hard 42 sites within 10 miles
Crumpton (CDP) 60 Moderately hard 127 sites within 10 miles
Romancoke (CDP) 143 Hard 16 sites within 10 miles

Water quality in Queen Anne's County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Stevensville Bayside-Queenslanding Not tested Not reported None
Centreville Town of Centreville None detected 0 lead · 663 unknown 1
Grasonville Grasonville Not tested 0 lead · 281 unknown None
Queenstown Town of Queenstown Not tested 0 lead · 227 unknown None
Sudlersville Town of Sudlersville Not tested 0 lead · 168 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next