Water hardness in Worcester County, MD

Water in Worcester County is soft, with a median of 51 mg/L (3 grains per gallon) across 72 monitoring sites.

about the same as the Maryland median (56 mg/L) 18th hardest of 24 counties
51mg/L
3 grains per gallon
Soft

Worcester County water at a glance

  • HardnessSoft (51 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 51 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites72
Lab samples183
Sample years2000–2023
Middle 50% of sites24–93 mg/L
Groundwater (wells, springs)65 mg/L · 51 sites
Surface water (rivers, lakes)37 mg/L · 21 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Worcester County

Prefilled with Worcester County's measured local hardness of 51 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Worcester County on the Maryland map

Washington CountyAllegany CountyQueen Anne's CountyCharles CountyAnne Arundel CountyGarrett CountySt. Mary's CountySomerset CountyCaroline CountyWicomico CountyCecil CountyHarford CountyBaltimore cityDorchester CountyCalvert CountyBaltimore CountyCarroll CountyFrederick CountyMontgomery CountyHoward CountyPrince George's CountyKent CountyTalbot County

Cities and communities in Worcester County

PlaceMedian mg/LClassBased on
Ocean Pines (CDP) 75 Moderately hard 37 sites within 10 miles
Ocean City 92 Moderately hard 22 sites within 10 miles
Berlin 59 Soft 37 sites within 10 miles
Pocomoke City 55 Soft 16 sites within 10 miles
West Ocean City (CDP) 78 Moderately hard 34 sites within 10 miles
Snow Hill 26 Soft 29 sites within 10 miles
Bishopville (CDP) 63 Moderately hard 32 sites within 10 miles
Newark (CDP) 29 Soft 39 sites within 10 miles
Girdletree (CDP) 38 Soft 28 sites within 10 miles
Whaleyville (CDP) 32 Soft 31 sites within 10 miles
Stockton (CDP) 38 Soft 28 sites within 10 miles

Water quality in Worcester County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Ocean Pines Ocean Pines 2 found 0 lead · 0 unknown None
Ocean City Town of Ocean City None detected 0 lead · 1,757 unknown 1
Berlin Town of Berlin 4 found 0 lead · 663 unknown None
Pocomoke City City of Pocomoke City None detected 0 lead · 1,774 unknown 9
Snow Hill Town of Snow Hill Not tested 0 lead · 912 unknown 4
Newark Newark Not tested 0 lead · 0 unknown None

Neighboring counties

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next