Water hardness in Aberdeen, MD

Water in Aberdeen is moderately hard, with a median of 93 mg/L (5.4 grains per gallon) across 30 monitoring sites within 10 miles.

66% harder than the Maryland median (56 mg/L) 49th hardest of 121 Maryland towns Population 18,006
93mg/L
5.4 grains per gallon
Moderately hard

Aberdeen tap water at a glance

  • HardnessModerately hard (93 mg/L, 5.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS8 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
  • Lead pipesNo known lead lines; 2,698 lines are still of unknown material.Check your own pipe →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 93 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.4 gpg (5.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites30
Lab samples383
Sample years2000–2023
Middle 50% of sites58–143 mg/L
Groundwater (wells, springs)98 mg/L · 22 sites
Surface water (rivers, lakes)78 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Aberdeen

Prefilled with Aberdeen's measured local hardness of 93 mg/L (5.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Aberdeen tap water

City of Aberdeen is the main public water system for Aberdeen. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Feb 2023 – Nov 2023. 8 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
9.4 ppt 2 of 6 samples —
PFPeA
perfluoropentanoic acid
8.7 ppt 2 of 6 samples —
PFOS
perfluorooctane sulfonic acid
8.6 ppt 2 of 6 samples 4 ppt
PFHxA
perfluorohexanoic acid
8.2 ppt 2 of 6 samples —
PFOA
perfluorooctanoic acid
7.6 ppt 2 of 6 samples 4 ppt
PFHxS
perfluorohexane sulfonic acid
5.8 ppt 2 of 6 samples 10 ppt*
PFBS
perfluorobutane sulfonic acid
4.5 ppt 2 of 6 samples —
PFHpA
perfluoroheptanoic acid
4.3 ppt 2 of 6 samples —

Other water systems serving parts of Aberdeen

Water systemPFAS detectedHighest PFOA / PFOSTested
Harford County D.P.W.
serves over 10,000 people
None detected — Jun 2023 – Mar 2024
Chapel Hill - Aberdeen Proving Grounds
serves over 10,000 people
None detected — Mar 2023 – Sep 2023
City of Havre De Grace
serves over 10,000 people
None detected — Jul 2024 – Apr 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Aberdeen

City of Aberdeen reported 2,698 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 2,698 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
2,698unknown material (100%)
0not lead (0%)

Other water systems serving parts of Aberdeen

Water systemService linesTotal
Harford County D.P.W.0 lead · 0 galvanized · 3,293 unknown3,293
Chapel Hill - Aberdeen Proving Grounds0 lead · 0 galvanized · 412 unknown412
City of Havre De Grace0 lead · 0 galvanized · 2,603 unknown2,603

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Aberdeen drinking water violations

EPA records show no health-based violations for City of Aberdeen since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Aberdeen

Water systemHealth-based violationsMonitoring/reporting
Harford County D.P.W.None3
Chapel Hill - Aberdeen Proving GroundsNone2
City of Havre De Grace517

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Aberdeen

SiteTypeDistanceMedianSamplesYears
CRANBERRY RUN AT ABERDEEN, MD
USGS Maryland Water Science Center
Stream 1.6 mi70 mg/L12000
HA De 299
USGS Maryland Water Science Center
Well 2.1 mi102 mg/L12000
HA Cf 169
USGS Maryland Water Science Center
Well 2.9 mi113 mg/L12003
UNNAMED TRIB TO ROMNEY CREEK NEAR PERRYMAN, MD
USGS Maryland Water Science Center
Stream 3 mi503 mg/L12000
HA Cf 171
USGS Maryland Water Science Center
Well 3.4 mi22 mg/L12000
HA Cf 176
USGS Maryland Water Science Center
Well 3.4 mi40 mg/L12000

Water hardness in towns near Aberdeen

TownDistanceMedianClass
Havre de Grace4 mi 76 mg/LModerately hard
Bel Air South7 mi 88 mg/LModerately hard
Bel Air9 mi 78 mg/LModerately hard
Edgewood9 mi 83 mg/LModerately hard
Bel Air North11 mi 76 mg/LModerately hard
Joppatowne12 mi 92 mg/LModerately hard
Perry Hall18 mi 248 mg/LVery hard
Middle River18 mi 262 mg/LVery hard
Rossville20 mi 262 mg/LVery hard
Elkton20 mi 14 mg/LSoft

Harford County

Aberdeen is in Harford County, where the median is 75 mg/L (moderately hard) across 65 sites.

See all of Harford County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Aberdeen, MD water: common questions

Do I need a water softener in Aberdeen?

Probably not. Water measured around Aberdeen is 5.4 gpg (93 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Aberdeen's drinking water?

The main public water system serving Aberdeen in EPA records is City of Aberdeen. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Aberdeen?

It depends on what you want to remove. In Aberdeen, EPA testing found PFBA, PFPeA and PFOS and 5 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next