Water hardness in Bel Air South, MD

Water in Bel Air South is moderately hard, with a median of 88 mg/L (5.1 grains per gallon) across 48 monitoring sites within 10 miles.

57% harder than the Maryland median (56 mg/L) 53rd hardest of 121 Maryland towns Population 47,709 (2010)
88mg/L
5.1 grains per gallon
Moderately hard

Bel Air South tap water at a glance

  • HardnessModerately hard (88 mg/L, 5.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 88 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.1 gpg (4.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites48
Lab samples117
Sample years2000–2019
Middle 50% of sites66–136 mg/L
Groundwater (wells, springs)83 mg/L · 43 sites
Surface water (rivers, lakes)119 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Bel Air South

Prefilled with Bel Air South's measured local hardness of 88 mg/L (5.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Bel Air South tap water

Bel Air South is served by more than one water system. These systems supply ZIP codes in Bel Air South and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Bel Air South

Water systemPFAS detectedHighest PFOA / PFOSTested
Harford County D.P.W.
serves over 10,000 people
None detected — Jun 2023 – Mar 2024
Maryland American Water Company
serves over 10,000 people
PFPeA, PFHxA, PFOA +6 more 9.3 / 9.1 ppt Jun 2023 – Mar 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Bel Air South

Bel Air South is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Bel Air South

Water systemService linesTotal
Harford County D.P.W.0 lead · 0 galvanized · 3,293 unknown3,293
Maryland American Water Company0 lead · 0 galvanized · 4,879 unknown4,879

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Bel Air South drinking water violations

Bel Air South is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Bel Air South

Water systemHealth-based violationsMonitoring/reporting
Harford County D.P.W.None3
Maryland American Water CompanyNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Bel Air South

SiteTypeDistanceMedianSamplesYears
HA Cd 201
USGS Maryland Water Science Center
Well 1.7 mi157 mg/L12000
PLUMTREE RUN NEAR BEL AIR, MD
USGS Maryland Water Science Center
Stream 2.2 mi119 mg/L242006–2010
HA Cd 199
USGS Maryland Water Science Center
Well 2.2 mi57 mg/L12000
HA De 298
USGS Maryland Water Science Center
Well 2.3 mi97 mg/L12000
BYNUM RUN AT BEL AIR, MD
USGS Maryland Water Science Center
Stream 2.5 mi120 mg/L242006–2010
JAMES RUN NEAR BELCAMP, MD
USGS Maryland Water Science Center
Stream 2.9 mi78 mg/L242006–2010

Water hardness in towns near Bel Air South

TownDistanceMedianClass
Bel Air3 mi 78 mg/LModerately hard
Bel Air North5 mi 76 mg/LModerately hard
Edgewood6 mi 83 mg/LModerately hard
Joppatowne7 mi 92 mg/LModerately hard
Aberdeen7 mi 93 mg/LModerately hard
Havre de Grace11 mi 76 mg/LModerately hard
Perry Hall11 mi 248 mg/LVery hard
Middle River13 mi 262 mg/LVery hard
Carney13 mi 248 mg/LVery hard
Rossville14 mi 262 mg/LVery hard

Harford County

Bel Air South is in Harford County, where the median is 75 mg/L (moderately hard) across 65 sites.

See all of Harford County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next