Water hardness in Northumberland County, PA
Water in Northumberland County is moderately hard, with a median of 94 mg/L (5.5 grains per gallon) across 106 monitoring sites.
Northumberland County water at a glance
- HardnessModerately hard (94 mg/L, 5.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 94 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.5 gpg (5.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Northumberland County
Prefilled with Northumberland County's measured local hardness of 94 mg/L (5.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Northumberland County on the Pennsylvania map
Cities and communities in Northumberland County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Sunbury | 104 | Moderately hard | 40 sites within 10 miles |
| Shamokin | 58 | Soft | 63 sites within 10 miles |
| Milton | 107 | Moderately hard | 42 sites within 10 miles |
| Mount Carmel | 71 | Moderately hard | 55 sites within 10 miles |
| Northumberland | 98 | Moderately hard | 51 sites within 10 miles |
| Kulpmont | 58 | Soft | 76 sites within 10 miles |
| Edgewood (CDP) | 58 | Soft | 61 sites within 10 miles |
| Watsontown | 96 | Moderately hard | 43 sites within 10 miles |
| Elysburg (CDP) | 91 | Moderately hard | 41 sites within 10 miles |
| Fairview-Ferndale (CDP) | 58 | Soft | 64 sites within 10 miles |
| Riverside | 90 | Moderately hard | 27 sites within 10 miles |
| Trevorton (CDP) | 80 | Moderately hard | 74 sites within 10 miles |
| Dewart (CDP) | 84 | Moderately hard | 47 sites within 10 miles |
| Marshallton (CDP) | 58 | Soft | 64 sites within 10 miles |
| Montandon (CDP) | 112 | Moderately hard | 45 sites within 10 miles |
| Kapp Heights (CDP) | 100 | Moderately hard | 43 sites within 10 miles |
| Atlas (CDP) | 68 | Moderately hard | 59 sites within 10 miles |
| Turbotville | 81 | Moderately hard | 49 sites within 10 miles |
| Marion Heights | 56 | Soft | 68 sites within 10 miles |
| Ranshaw (CDP) | 58 | Soft | 69 sites within 10 miles |
| Tharptown (Uniontown) (CDP) | 58 | Soft | 62 sites within 10 miles |
| Dalmatia (CDP) | 71 | Moderately hard | 41 sites within 10 miles |
| Herndon | 96 | Moderately hard | 42 sites within 10 miles |
| Snydertown | 98 | Moderately hard | 42 sites within 10 miles |
| McEwensville | 92 | Moderately hard | 50 sites within 10 miles |
| Strong (CDP) | 67 | Moderately hard | 58 sites within 10 miles |
Water quality in Northumberland County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Sunbury | Municipal Authority Sunbury | None detected | 2 lead · 1 unknown | 1 |
Neighboring counties
- Montour County74 mg/L
- Union County16 mg/L
- Snyder County60 mg/L
- Columbia County36 mg/L
- Schuylkill County82 mg/L
- Dauphin County76 mg/L
Pennsylvania
The statewide median is 82 mg/L (moderately hard) from 4,757 sites.
Pennsylvania hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.