Water hardness in Clinton County, PA
Water in Clinton County is moderately hard, with a median of 88 mg/L (5.1 grains per gallon) across 139 monitoring sites.
Clinton County water at a glance
- HardnessModerately hard (88 mg/L, 5.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 88 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.1 gpg (4.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Clinton County
Prefilled with Clinton County's measured local hardness of 88 mg/L (5.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Clinton County on the Pennsylvania map
Cities and communities in Clinton County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Lock Haven | 120 | Moderately hard | 57 sites within 10 miles |
| Avis | 76 | Moderately hard | 54 sites within 10 miles |
| Mill Hall | 130 | Hard | 64 sites within 10 miles |
| Dunnstown (CDP) | 111 | Moderately hard | 53 sites within 10 miles |
| Flemington | 130 | Hard | 64 sites within 10 miles |
| Castanea (CDP) | 130 | Hard | 69 sites within 10 miles |
| Renovo | 42 | Soft | 56 sites within 10 miles |
| Beech Creek | 130 | Hard | 61 sites within 10 miles |
| McElhattan (CDP) | 112 | Moderately hard | 65 sites within 10 miles |
| Lamar (CDP) | 143 | Hard | 60 sites within 10 miles |
| Rote (CDP) | 132 | Hard | 70 sites within 10 miles |
| Loganton | 130 | Hard | 49 sites within 10 miles |
| South Renovo | 31 | Soft | 49 sites within 10 miles |
| Clintondale (CDP) | 143 | Hard | 61 sites within 10 miles |
| Farwell (CDP) | 36 | Soft | 39 sites within 10 miles |
| Hyner (CDP) | 20 | Soft | 29 sites within 10 miles |
| Mackeyville (CDP) | 138 | Hard | 74 sites within 10 miles |
| North Bend (CDP) | 26 | Soft | 38 sites within 10 miles |
| Salona (CDP) | 132 | Hard | 70 sites within 10 miles |
| Tylersville (CDP) | 140 | Hard | 57 sites within 10 miles |
| Woolrich (CDP) | 85 | Moderately hard | 63 sites within 10 miles |
Water quality in Clinton County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Lock Haven | City of Lock Haven Water Dept | None detected | 0 lead · 939 unknown | 1 |
| Beech Creek | Beech Creek Borough Authority | Not tested | 0 lead · 367 unknown | None |
Neighboring counties
- Centre County162 mg/L
- Lycoming County40 mg/L
- Cameron County24 mg/L
- Union County16 mg/L
- Potter County26 mg/L
- Tioga County55 mg/L
Pennsylvania
The statewide median is 82 mg/L (moderately hard) from 4,757 sites.
Pennsylvania hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.