Water hardness in Franklin County, PA
Water in Franklin County is moderately hard, with a median of 70 mg/L (4.1 grains per gallon) across 67 monitoring sites.
Franklin County water at a glance
- HardnessModerately hard (70 mg/L, 4.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 70 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.1 gpg (3.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Franklin County
Prefilled with Franklin County's measured local hardness of 70 mg/L (4.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Franklin County on the Pennsylvania map
Cities and communities in Franklin County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Chambersburg | 77 | Moderately hard | 37 sites within 10 miles |
| Waynesboro | 17 | Soft | 14 sites within 10 miles |
| Shippensburg | 62 | Moderately hard | 61 sites within 10 miles |
| Greencastle | 358 | Very hard | 4 sites within 10 miles |
| Fayetteville (CDP) | 12 | Soft | 41 sites within 10 miles |
| State Line (CDP) | 358 | Very hard | 4 sites within 10 miles |
| Wayne Heights (CDP) | 17 | Soft | 16 sites within 10 miles |
| Guilford (CDP) | 25 | Soft | 53 sites within 10 miles |
| Mont Alto | 13 | Soft | 39 sites within 10 miles |
| Mercersburg | 174 | Hard | 9 sites within 10 miles |
| Scotland (CDP) | 59 | Soft | 62 sites within 10 miles |
| Marion (CDP) | 138 | Hard | 25 sites within 10 miles |
| Pen Mar (CDP) | 13 | Soft | 13 sites within 10 miles |
| Rouzerville (CDP) | 17 | Soft | 14 sites within 10 miles |
| Blue Ridge Summit (CDP) | 12 | Soft | 14 sites within 10 miles |
| Fort Loudon (CDP) | 136 | Hard | 14 sites within 10 miles |
| Orrstown | 100 | Moderately hard | 63 sites within 10 miles |
| Burnt Cabins (CDP) | 72 | Moderately hard | 21 sites within 10 miles |
Water quality in Franklin County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Chambersburg | Chambersburg Boro Water SYS | None detected | 0 lead · 1,949 unknown | None |
| Waynesboro | Boro of Waynesboro | None detected | 0 lead · 5,146 unknown | None |
| Mont Alto | Mont Alto Municipal Authority | Not tested | 0 lead · 453 unknown | 1 |
| Marion | Marion TWP WTP | Not tested | 0 lead · 76 unknown | 3 |
Neighboring counties
- Fulton County70 mg/L
- Adams County74 mg/L
- Cumberland County115 mg/L
- Huntingdon County104 mg/L
- Perry County73 mg/L
- Bedford County144 mg/L
Pennsylvania
The statewide median is 82 mg/L (moderately hard) from 4,757 sites.
Pennsylvania hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.