Water hardness in Hopkins County, TX
Water in Hopkins County is moderately hard, with a median of 76 mg/L (4.5 grains per gallon) across 5 monitoring sites.
Hopkins County water at a glance
- HardnessModerately hard (76 mg/L, 4.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 76 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.5 gpg (4.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Hopkins County
Prefilled with Hopkins County's measured local hardness of 76 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Hopkins County on the Texas map
Cities and communities in Hopkins County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Sulphur Springs | 76 | Moderately hard | county median |
| Como | 76 | Moderately hard | county median |
| Cumby | 76 | Moderately hard | county median |
| Tira | 76 | Moderately hard | 5 sites within 10 miles |
Water quality in Hopkins County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Sulphur Springs | City of Sulphur Springs | None detected | 0 lead · 1,903 unknown | 1 |
| Como | City of Como | Not tested | 0 lead · 0 unknown | None |
| Cumby | City of Cumby | None detected | Not reported | 1 (1 open) |
Neighboring counties
- Delta County70 mg/L
- Franklin County44 mg/L
- Rains County52 mg/L
- Wood County45 mg/L
- Hunt County78 mg/L
- Titus County104 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.