Water hardness in Grayson County, TX
Water in Grayson County is moderately hard, with a median of 101 mg/L (5.9 grains per gallon) across 10 monitoring sites.
Grayson County water at a glance
- HardnessModerately hard (101 mg/L, 5.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 101 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.9 gpg (5.7 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Grayson County
Prefilled with Grayson County's measured local hardness of 101 mg/L (5.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Grayson County on the Texas map
Cities and communities in Grayson County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Sherman | 101 | Moderately hard | county median |
| Denison | 148 | Hard | 3 sites within 10 miles |
| Van Alstyne | 101 | Moderately hard | county median |
| Whitesboro | 49 | Soft | 4 sites within 10 miles |
| Howe | 101 | Moderately hard | county median |
| Pottsboro | 226 | Very hard | 4 sites within 10 miles |
| Gunter | 98 | Moderately hard | 5 sites within 10 miles |
| Preston (CDP) | 101 | Moderately hard | county median |
| Collinsville | 91 | Moderately hard | 9 sites within 10 miles |
| Bells | 101 | Moderately hard | county median |
| Tioga | 98 | Moderately hard | 11 sites within 10 miles |
| Sherwood Shores (CDP) | 101 | Moderately hard | county median |
| Southmayd | 101 | Moderately hard | county median |
| Tom Bean | 101 | Moderately hard | county median |
| Knollwood | 148 | Hard | 3 sites within 10 miles |
| Sadler | 14 | Soft | 3 sites within 10 miles |
| Dorchester | 101 | Moderately hard | county median |
Water quality in Grayson County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Sherman | City of Sherman | 3 found | 3 lead · 11,865 unknown | None |
| Denison | City of Denison | None detected | 18 lead · 7,837 unknown | None |
| Van Alstyne | City of Van Alstyne | 1 found | 8 lead · 307 unknown | None |
| Whitesboro | City of Whitesboro | None detected | 0 lead · 0 unknown | None |
| Howe | City of Howe | Not tested | 0 lead · 668 unknown | None |
| Pottsboro | City of Pottsboro | Not tested | 0 lead · 1,453 unknown | None |
| Gunter | City of Gunter | Not tested | 0 lead · 7 unknown | None |
| Collinsville | City of Collinsville | Not tested | 0 lead · 495 unknown | None |
| Bells | City of Bells | Not tested | Not reported | 1 (1 open) |
| Tioga | City of Tioga | Not tested | 0 lead · 0 unknown | None |
| Sherwood Shores | Sherwood Shores | Not tested | 0 lead · 0 unknown | None |
| Southmayd | City of Southmayd | Not tested | 0 lead · 0 unknown | 2 |
| Tom Bean | City of Tom Bean | Not tested | 0 lead · 8 unknown | None |
| Knollwood | City of Knollwood | Not tested | 0 lead · 0 unknown | None |
| Sadler | City of Sadler | Not tested | 0 lead · 0 unknown | None |
| Dorchester | City of Dorchester | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Collin County111 mg/L
- Cooke County104 mg/L
- Fannin County96 mg/L
- Denton County126 mg/L
- Hunt County78 mg/L
- Rockwall County116 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.