Water hardness in Gregg County, TX
Water in Gregg County is soft, with a median of 48 mg/L (2.8 grains per gallon) across 17 monitoring sites.
Gregg County water at a glance
- HardnessSoft (48 mg/L, 2.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 48 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.8 gpg (2.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Gregg County
Prefilled with Gregg County's measured local hardness of 48 mg/L (2.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Gregg County on the Texas map
Cities and communities in Gregg County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Longview | 50 | Soft | 16 sites within 10 miles |
| Kilgore | 48 | Soft | 16 sites within 10 miles |
| Gladewater | 48 | Soft | 12 sites within 10 miles |
| White Oak | 50 | Soft | 16 sites within 10 miles |
| Lake Cherokee (CDP) | 46 | Soft | 4 sites within 10 miles |
| Liberty City (CDP) | 48 | Soft | 14 sites within 10 miles |
| Lakeport | 48 | Soft | 13 sites within 10 miles |
| East Mountain | 51 | Soft | 15 sites within 10 miles |
| Clarksville City | 52 | Soft | 17 sites within 10 miles |
| Easton | 22 | Soft | 6 sites within 10 miles |
| Warren City | 51 | Soft | 17 sites within 10 miles |
Water quality in Gregg County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Longview | City of Longview | None detected | 0 lead · 2,484 unknown | None |
| Kilgore | City of Kilgore | 1 found | Not reported | 1 (1 open) |
| Gladewater | City of Gladewater | None detected | Not reported | 28 (1 open) |
| White Oak | City of White Oak | None detected | 7 lead · 83 unknown | None |
| Liberty City | City of Liberty | None detected | 0 lead · 1 unknown | None |
| East Mountain | City of East Mountain | Not tested | 0 lead · 0 unknown | 1 |
| Clarksville City | City of Clarksville | Not tested | Not reported | 5 |
| Warren City | City of Warren City | Not tested | 1 lead · 25 unknown | None |
Neighboring counties
- Upshur County38 mg/L
- Harrison County28 mg/L
- Rusk County24 mg/L
- Smith County47 mg/L
- Marion County28 mg/L
- Camp County38 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.