Water hardness in San Augustine County, TX
Water in San Augustine County is soft, with a median of 28 mg/L (1.6 grains per gallon) across 5 monitoring sites.
San Augustine County water at a glance
- HardnessSoft (28 mg/L, 1.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 28 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.6 gpg (1.6 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for San Augustine County
Prefilled with San Augustine County's measured local hardness of 28 mg/L (1.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
San Augustine County on the Texas map
Cities and communities in San Augustine County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| San Augustine | 16 | Soft | 3 sites within 10 miles |
| Broaddus | 28 | Soft | 4 sites within 10 miles |
Water quality in San Augustine County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| San Augustine | City of San Augustine | Not tested | 1 lead · 285 unknown | 22 |
| Broaddus | City of Broaddus | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Sabine County32 mg/L
- Angelina County72 mg/L
- Shelby County48 mg/L
- Nacogdoches County31 mg/L
- Tyler County27 mg/L
- Jasper County29 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.