Water hardness in Cooke County, TX
Water in Cooke County is moderately hard, with a median of 104 mg/L (6 grains per gallon) across 11 monitoring sites.
Cooke County water at a glance
- HardnessModerately hard (104 mg/L, 6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 104 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6 gpg (5.8 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Cooke County
Prefilled with Cooke County's measured local hardness of 104 mg/L (6.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Cooke County on the Texas map
Cities and communities in Cooke County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Gainesville | 124 | Hard | 4 sites within 10 miles |
| Lake Kiowa (CDP) | 98 | Moderately hard | 10 sites within 10 miles |
| Muenster | 104 | Moderately hard | county median |
| Lindsay | 137 | Hard | 3 sites within 10 miles |
| Valley View | 105 | Moderately hard | 11 sites within 10 miles |
| Road Runner | 103 | Moderately hard | 17 sites within 10 miles |
| Callisburg | 84 | Moderately hard | 3 sites within 10 miles |
| Oak Ridge | 84 | Moderately hard | 5 sites within 10 miles |
| Myra (CDP) | 104 | Moderately hard | county median |
Water quality in Cooke County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Gainesville | City of Gainesville | None detected | 0 lead · 0 unknown | 4 |
| Muenster | City of Muenster | Not tested | 0 lead · 0 unknown | None |
| Lindsay | City of Lindsay | Not tested | 0 lead · 177 unknown | None |
| Valley View | City of Valley View | Not tested | 0 lead · 0 unknown | None |
| Callisburg | City of Callisburg | Not tested | 0 lead · 44 unknown | None |
| Oak Ridge | Oak Ridge Water System | Not tested | 0 lead · 0 unknown | 1 |
| Myra | Myra Water System | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- Denton County126 mg/L
- Grayson County101 mg/L
- Wise County475 mg/L
- Collin County111 mg/L
- Clay County118 mg/L
- Tarrant County355 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.