Water hardness in Sulphur Springs, TX
Water in Sulphur Springs is moderately hard, with a median of 76 mg/L (4.5 grains per gallon) across Hopkins County.
There are not enough monitoring sites within 10 miles of Sulphur Springs, so this page uses the Hopkins County median.
Sulphur Springs tap water at a glance
- HardnessModerately hard (76 mg/L, 4.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 1,903 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 76 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.5 gpg (4.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Sulphur Springs
Prefilled with Sulphur Springs's measured local hardness of 76 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Sulphur Springs tap water
City of Sulphur Springs is the main public water system for Sulphur Springs. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Apr 2023 – Jan 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Sulphur Springs
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Martin Springs WSC serves 10,000 people or fewer | None detected | — | Jan 2025 – Jul 2025 |
| North Hopkins WSC serves 10,000 people or fewer | None detected | — | Mar 2025 – Dec 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Sulphur Springs
City of Sulphur Springs reported 6,682 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 1,903 lines are still of unknown material.
Other water systems serving parts of Sulphur Springs
| Water system | Service lines | Total |
|---|---|---|
| Martin Springs WSC | 0 lead · 0 galvanized · 0 unknown | 1,318 |
| North Hopkins WSC | 0 lead · 0 galvanized · 0 unknown | 2,784 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Sulphur Springs drinking water violations
EPA records show 1 health-based violation for City of Sulphur Springs since 2016, all since resolved or closed. The most recent began in Dec 2022. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Surface water treatment (filtration/turbidity) filtration requirements that protect against microbes such as Cryptosporidium | Treatment requirement not met | 1 | Dec 2022 | Resolved/closed |
Other water systems serving parts of Sulphur Springs
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Martin Springs WSC | None | 3 |
| North Hopkins WSC | None | 4 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Water hardness in towns near Sulphur Springs
| Town | Distance | Median | Class |
|---|---|---|---|
| Greenville | 29 mi | 78 mg/L | Moderately hard |
| Paris | 37 mi | 57 mg/L | Soft |
| Mount Pleasant | 37 mi | 100 mg/L | Moderately hard |
| Royse City | 42 mi | 100 mg/L | Moderately hard |
| Bonham | 45 mi | 96 mg/L | Moderately hard |
| Fate | 47 mi | 117 mg/L | Moderately hard |
| Terrell | 48 mi | 166 mg/L | Hard |
| Rockwall | 50 mi | 118 mg/L | Moderately hard |
| Princeton | 52 mi | 111 mg/L | Moderately hard |
| Wylie | 53 mi | 111 mg/L | Moderately hard |
Hopkins County
Sulphur Springs is in Hopkins County, where the median is 76 mg/L (moderately hard) across 5 sites.
See all of Hopkins County →Sulphur Springs, TX water: common questions
Do I need a water softener in Sulphur Springs?
Probably not. Water measured around Sulphur Springs is 4.5 gpg (76 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 8,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Sulphur Springs's drinking water?
The main public water system serving Sulphur Springs in EPA records is City of Sulphur Springs. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Sulphur Springs?
It depends on what you want to remove. In Sulphur Springs, the system had 1 health-based violation since 2016, for the Interim Enhanced Surface Water Treatment Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- How to tell if your home has a lead pipe1,903 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.