Water hardness in Spanaway, WA
Water in Spanaway is soft, with a median of 52 mg/L (3 grains per gallon) across 62 monitoring sites within 10 miles.
Spanaway tap water at a glance
- HardnessSoft (52 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS6 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 52 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Spanaway
Prefilled with Spanaway's measured local hardness of 52 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Spanaway tap water
Spanaway Water Company is the main public water system for Spanaway. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 20 samples taken Aug 2024 – Feb 2025. 6 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFOS perfluorooctane sulfonic acid | 8.3 ppt | 5 of 20 samples | 4 ppt |
| PFBS perfluorobutane sulfonic acid | 7.5 ppt | 7 of 20 samples | — |
| PFOA perfluorooctanoic acid | 6.2 ppt | 1 of 20 samples | 4 ppt |
| PFHxA perfluorohexanoic acid | 5.9 ppt | 2 of 20 samples | — |
| PFPeA perfluoropentanoic acid | 5.8 ppt | 3 of 20 samples | — |
| PFHxS perfluorohexane sulfonic acid | 3.7 ppt | 2 of 20 samples | 10 ppt* |
Other water systems serving parts of Spanaway
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Parkland Light & Water Company serves over 10,000 people | PFOS, PFBS, PFOA +3 more | 6.2 / 13.8 ppt | Feb 2024 – Aug 2024 |
| City of Tacoma Water Division serves over 10,000 people | PFHxS, PFBS | — | Jan 2025 – Oct 2025 |
| Summit Water & Supply serves over 10,000 people | PFPeA | — | May 2023 – Nov 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Spanaway
Spanaway Water Company reported 10,935 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Spanaway
| Water system | Service lines | Total |
|---|---|---|
| Parkland Light & Water Company | 0 lead · 0 galvanized · 2,644 unknown | 10,644 |
| City of Tacoma Water Division | 0 lead · 0 galvanized · 0 unknown | 114,107 |
| Summit Water & Supply | 0 lead · 0 galvanized · 0 unknown | 4,960 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Spanaway drinking water violations
EPA records show no health-based violations for Spanaway Water Company since 2016.
Other water systems serving parts of Spanaway
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Parkland Light & Water Company | None | 3 |
| City of Tacoma Water Division | None | 0 |
| Summit Water & Supply | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Spanaway
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 19N/03E-27D01 SU-13 USGS Washington Water Science Center | Well | 0.9 mi | 55 mg/L | 1 | 2016 |
| 19N/03E-21C01 UR-32 USGS Washington Water Science Center | Well | 1.9 mi | 53 mg/L | 9 | 2000–2012 |
| 19N/03E-23G03 UR-26 USGS Washington Water Science Center | Well | 2.3 mi | 64 mg/L | 1 | 2005 |
| 18N/03E-12K01 UR-23 USGS Washington Water Science Center | Well | 3.9 mi | 45 mg/L | 1 | 2005 |
| 19N/02E-26L01 MW-LC-026D USGS Washington Water Science Center | Well | 4.5 mi | 52 mg/L | 1 | 2000 |
| 19N/02E-26F01 LC-55D USGS Washington Water Science Center | Well | 4.7 mi | 39 mg/L | 1 | 2000 |
Water hardness in towns near Spanaway
| Town | Distance | Median | Class |
|---|---|---|---|
| Frederickson | 3 mi | 52 mg/L | Soft |
| Parkland | 3 mi | 52 mg/L | Soft |
| Elk Plain | 5 mi | 54 mg/L | Soft |
| South Hill | 7 mi | 64 mg/L | Moderately hard |
| Lakewood | 7 mi | 51 mg/L | Soft |
| Fort Lewis | 7 mi | 51 mg/L | Soft |
| Graham | 8 mi | 59 mg/L | Soft |
| Puyallup | 8 mi | 62 mg/L | Moderately hard |
| Fife | 10 mi | 70 mg/L | Moderately hard |
| University Place | 10 mi | 51 mg/L | Soft |
Pierce County
Spanaway is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.
See all of Pierce County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Spanaway, WA water: common questions
Do I need a water softener in Spanaway?
Probably not. Water measured around Spanaway is 3 gpg (52 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Spanaway's drinking water?
The main public water system serving Spanaway in EPA records is Spanaway Water Company. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Spanaway?
It depends on what you want to remove. In Spanaway, EPA testing found PFOS, PFBS and PFOA and 3 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 6 PFAS in Spanaway's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.