Water hardness in South Hill, WA

Water in South Hill is moderately hard, with a median of 64 mg/L (3.7 grains per gallon) across 17 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 61st hardest of 122 Washington towns Population 52,431 (2010)
64mg/L
3.7 grains per gallon
Moderately hard

South Hill tap water at a glance

  • HardnessModerately hard (64 mg/L, 3.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 64 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.7 gpg (3.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites17
Lab samples58
Sample years2000–2016
Middle 50% of sites52–89 mg/L
Groundwater (wells, springs)59 mg/L · 14 sites
Surface water (rivers, lakes)83 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for South Hill

Prefilled with South Hill's measured local hardness of 64 mg/L (3.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in South Hill tap water

South Hill is served by more than one water system. These systems supply ZIP codes in South Hill and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving South Hill

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Tacoma Water Division
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025
Firgrove Mutual INC
serves over 10,000 people
PFOS, PFBS, PFOA 4.4 / 8.6 ppt Jan 2023 – Jan 2024
Fruitland Mutual Water Company
serves over 10,000 people
PFBS, PFOA, PFPeA +1 more 4 / ND ppt Apr 2023 – Jan 2024
City of Puyallup
serves over 10,000 people
PFBS — Dec 2023 – Sep 2024
Southwood Water System
serves over 10,000 people
PFPeA, PFHxA, PFBA +3 more 6.2 / 8.9 ppt Apr 2024 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in South Hill

South Hill is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving South Hill

Water systemService linesTotal
City of Tacoma Water Division0 lead · 0 galvanized · 0 unknown114,107
Firgrove Mutual INC0 lead · 0 galvanized · 0 unknown354
Fruitland Mutual Water Company0 lead · 0 galvanized · 1,057 unknown3,457
City of Puyallup0 lead · 0 galvanized · 2,681 unknown11,735
Southwood0 lead · 0 galvanized · 10,270 unknown15,670

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

South Hill drinking water violations

South Hill is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving South Hill

Water systemHealth-based violationsMonitoring/reporting
City of Tacoma Water DivisionNone0
Firgrove Mutual INCNone0
Fruitland Mutual Water CompanyNone9
City of PuyallupNone0
Southwood Water SystemNone4

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to South Hill

SiteTypeDistanceMedianSamplesYears
19N/04E-22A01 UR-29A
USGS Washington Water Science Center
Well 0.6 mi97 mg/L12005
19N/04E-23N01 UR-30
USGS Washington Water Science Center
Well 0.9 mi310 mg/L12005
19N/04E-02F02 UR-34
USGS Washington Water Science Center
Well 3.4 mi33 mg/L12005
20N/04E-36P02 UR-35B
USGS Washington Water Science Center
Well 3.9 mi127 mg/L92000–2012
18N/04E-09K03 UR-31
USGS Washington Water Science Center
Well 4.4 mi54 mg/L12005
19N/03E-23G03 UR-26
USGS Washington Water Science Center
Well 5.1 mi64 mg/L12005

Water hardness in towns near South Hill

TownDistanceMedianClass
Puyallup4 mi 62 mg/LModerately hard
Frederickson4 mi 52 mg/LSoft
Graham6 mi 59 mg/LSoft
Elk Plain7 mi 54 mg/LSoft
Spanaway7 mi 52 mg/LSoft
Prairie Ridge7 mi 54 mg/LSoft
Parkland7 mi 52 mg/LSoft
Edgewood8 mi 76 mg/LModerately hard
Sumner8 mi 76 mg/LModerately hard
Bonney Lake8 mi 61 mg/LModerately hard

Pierce County

South Hill is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.

See all of Pierce County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next