Water hardness in Puyallup, WA
Water in Puyallup is moderately hard, with a median of 62 mg/L (3.6 grains per gallon) across 22 monitoring sites within 10 miles.
Puyallup tap water at a glance
- HardnessModerately hard (62 mg/L, 3.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 2,681 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 62 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.6 gpg (3.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Puyallup
Prefilled with Puyallup's measured local hardness of 62 mg/L (3.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Puyallup tap water
City of Puyallup is the main public water system for Puyallup. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 16 samples taken Dec 2023 – Sep 2024. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBS perfluorobutane sulfonic acid | 4.4 ppt | 2 of 16 samples | — |
Other water systems serving parts of Puyallup
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Southwood Water System serves over 10,000 people | PFPeA, PFHxA, PFBA +3 more | 6.2 / 8.9 ppt | Apr 2024 – Oct 2025 |
| City of Tacoma Water Division serves over 10,000 people | PFHxS, PFBS | — | Jan 2025 – Oct 2025 |
| Firgrove Mutual INC serves over 10,000 people | PFOS, PFBS, PFOA | 4.4 / 8.6 ppt | Jan 2023 – Jan 2024 |
| Fruitland Mutual Water Company serves over 10,000 people | PFBS, PFOA, PFPeA +1 more | 4 / ND ppt | Apr 2023 – Jan 2024 |
| Summit Water & Supply serves over 10,000 people | PFPeA | — | May 2023 – Nov 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Puyallup
City of Puyallup reported 11,735 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 2,681 lines are still of unknown material.
Other water systems serving parts of Puyallup
| Water system | Service lines | Total |
|---|---|---|
| Southwood | 0 lead · 0 galvanized · 10,270 unknown | 15,670 |
| City of Tacoma Water Division | 0 lead · 0 galvanized · 0 unknown | 114,107 |
| Firgrove Mutual INC | 0 lead · 0 galvanized · 0 unknown | 354 |
| Fruitland Mutual Water Company | 0 lead · 0 galvanized · 1,057 unknown | 3,457 |
| Summit Water & Supply | 0 lead · 0 galvanized · 0 unknown | 4,960 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Puyallup drinking water violations
EPA records show no health-based violations for City of Puyallup since 2016.
Other water systems serving parts of Puyallup
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Southwood Water System | None | 4 |
| City of Tacoma Water Division | None | 0 |
| Firgrove Mutual INC | None | 0 |
| Fruitland Mutual Water Company | None | 9 |
| Summit Water & Supply | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Puyallup
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| PUYALLUP RIVER AT MERIDIAN ST Washington Department Of Ecology | River/Stream | 1.6 mi | 24 mg/L | 4 | 2011–2012 |
| 19N/04E-02F02 UR-34 USGS Washington Water Science Center | Well | 1.7 mi | 33 mg/L | 1 | 2005 |
| 20N/04E-36P02 UR-35B USGS Washington Water Science Center | Well | 2.5 mi | 127 mg/L | 9 | 2000–2012 |
| 19N/04E-22A01 UR-29A USGS Washington Water Science Center | Well | 4 mi | 97 mg/L | 1 | 2005 |
| 19N/04E-23N01 UR-30 USGS Washington Water Science Center | Well | 4.7 mi | 310 mg/L | 1 | 2005 |
| HYLEBOS CREEK @ 8TH ST. E Washington Department Of Ecology | River/Stream | 5.6 mi | 93 mg/L | 6 | 2010–2011 |
Water hardness in towns near Puyallup
| Town | Distance | Median | Class |
|---|---|---|---|
| Edgewood | 4 mi | 76 mg/L | Moderately hard |
| South Hill | 4 mi | 64 mg/L | Moderately hard |
| Sumner | 4 mi | 76 mg/L | Moderately hard |
| Fife | 5 mi | 70 mg/L | Moderately hard |
| Bonney Lake | 6 mi | 61 mg/L | Moderately hard |
| Lake Tapps | 7 mi | 61 mg/L | Moderately hard |
| Lakeland South | 7 mi | 61 mg/L | Moderately hard |
| Frederickson | 7 mi | 52 mg/L | Soft |
| Parkland | 7 mi | 52 mg/L | Soft |
| Prairie Ridge | 8 mi | 54 mg/L | Soft |
Pierce County
Puyallup is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.
See all of Pierce County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Puyallup, WA water: common questions
Do I need a water softener in Puyallup?
Probably not. Water measured around Puyallup is 3.6 gpg (62 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Puyallup's drinking water?
The main public water system serving Puyallup in EPA records is City of Puyallup. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Puyallup?
It depends on what you want to remove. In Puyallup, EPA testing found PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 1 PFAS in Puyallup's main water system.
- How to tell if your home has a lead pipe2,681 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.