Water hardness in Lake Tapps, WA

Water in Lake Tapps is moderately hard, with a median of 61 mg/L (3.6 grains per gallon) across 16 monitoring sites within 10 miles.

18% softer than the Washington median (74 mg/L) 70th hardest of 122 Washington towns Population 11,859 (2010)
61mg/L
3.6 grains per gallon
Moderately hard

Lake Tapps tap water at a glance

  • HardnessModerately hard (61 mg/L, 3.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 61 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.6 gpg (3.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples142
Sample years2000–2017
Middle 50% of sites46–94 mg/L
Groundwater (wells, springs)112 mg/L · 6 sites
Surface water (rivers, lakes)59 mg/L · 10 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Lake Tapps

Prefilled with Lake Tapps's measured local hardness of 61 mg/L (3.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Lake Tapps tap water

Lake Tapps is served by more than one water system. These systems supply ZIP codes in Lake Tapps and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Lake Tapps

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Tacoma Water Division
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025
Bonney Lake Water Department City
serves over 10,000 people
PFBS — May 2024 – Feb 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Lake Tapps

Lake Tapps is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Lake Tapps

Water systemService linesTotal
City of Tacoma Water Division0 lead · 0 galvanized · 0 unknown114,107
Bonney Lake Water Department City0 lead · 0 galvanized · 17 unknown22,128

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Lake Tapps drinking water violations

Lake Tapps is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Lake Tapps

Water systemHealth-based violationsMonitoring/reporting
City of Tacoma Water DivisionNone0
Bonney Lake Water Department CityNone4

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Lake Tapps

SiteTypeDistanceMedianSamplesYears
Mouth Site 0048
Muckleshoot Indian Tribe (Tribal)
River/Stream 2.8 mi61 mg/L212014–2017
Upper Site 0050
Muckleshoot Indian Tribe (Tribal)
River/Stream 3.2 mi93 mg/L212014–2017
408 Site 0048
Muckleshoot Indian Tribe (Tribal)
River/Stream 3.3 mi50 mg/L152014–2017
Mainstem Site 3
Muckleshoot Indian Tribe (Tribal)
River/Stream 3.8 mi23 mg/L212014–2017
20N/04E-36P02 UR-35B
USGS Washington Water Science Center
Well 5.4 mi127 mg/L92000–2012
BIG SOOS CREEK ABOVE HATCHERY NEAR AUBURN, WA
USGS Washington Water Science Center
Stream 5.7 mi58 mg/L102015

Water hardness in towns near Lake Tapps

TownDistanceMedianClass
Bonney Lake2 mi 61 mg/LModerately hard
Sumner3 mi 76 mg/LModerately hard
Auburn5 mi 61 mg/LModerately hard
Edgewood5 mi 76 mg/LModerately hard
Prairie Ridge6 mi 54 mg/LSoft
Lakeland South6 mi 61 mg/LModerately hard
Puyallup7 mi 62 mg/LModerately hard
Lake Morton-Berrydale8 mi 55 mg/LSoft
Fife8 mi 70 mg/LModerately hard
Enumclaw9 mi 55 mg/LSoft

Pierce County

Lake Tapps is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.

See all of Pierce County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next