Water hardness in Fife, WA

Water in Fife is moderately hard, with a median of 70 mg/L (4.1 grains per gallon) across 16 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 49th hardest of 122 Washington towns Population 10,723
70mg/L
4.1 grains per gallon
Moderately hard

Fife tap water at a glance

  • HardnessModerately hard (70 mg/L, 4.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS2 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 70 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.1 gpg (3.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples87
Sample years2000–2017
Middle 50% of sites52–103 mg/L
Groundwater (wells, springs)97 mg/L · 9 sites
Surface water (rivers, lakes)63 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Fife

Prefilled with Fife's measured local hardness of 70 mg/L (4.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Fife tap water

Fife Dept of Public Works is the main public water system for Fife. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jan 2025 – Oct 2025. 2 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFHxS
perfluorohexane sulfonic acid
5 ppt 2 of 8 samples 10 ppt*
PFBS
perfluorobutane sulfonic acid
4 ppt 2 of 8 samples —

Other water systems serving parts of Fife

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Tacoma Water Division
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Fife

Fife Dept of Public Works reported 3,005 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
3,005not lead (100%)

Other water systems serving parts of Fife

Water systemService linesTotal
City of Tacoma Water Division0 lead · 0 galvanized · 0 unknown114,107

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Fife drinking water violations

EPA records show no health-based violations for Fife Dept of Public Works since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Fife

Water systemHealth-based violationsMonitoring/reporting
City of Tacoma Water DivisionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Fife

SiteTypeDistanceMedianSamplesYears
HYLEBOS CREEK @ 8TH ST. E
Washington Department Of Ecology
River/Stream 1.2 mi93 mg/L62010–2011
SWAN CREEK AT PIONEER WAY TACOMA, WA
USGS Washington Water Science Center
Stream 1.9 mi83 mg/L102015
PUYALLUP RIVER AT MERIDIAN ST
Washington Department Of Ecology
River/Stream 3.4 mi24 mg/L42011–2012
21N/04E-07R02 SWQA09
USGS Washington Water Science Center
Well 6 mi148 mg/L12016
19N/04E-02F02 UR-34
USGS Washington Water Science Center
Well 6.2 mi33 mg/L12005
MILL CREEK AT PEASLEY CANYON RD S NR AUBURN, WA
USGS Washington Water Science Center
Stream 6.3 mi76 mg/L102015

Water hardness in towns near Fife

TownDistanceMedianClass
Edgewood3 mi 76 mg/LModerately hard
Lakeland South4 mi 61 mg/LModerately hard
Puyallup5 mi 62 mg/LModerately hard
Tacoma5 mi 63 mg/LModerately hard
Sumner5 mi 76 mg/LModerately hard
Federal Way6 mi 80 mg/LModerately hard
Parkland7 mi 52 mg/LSoft
Lakeland North8 mi 61 mg/LModerately hard
Auburn8 mi 61 mg/LModerately hard
South Hill8 mi 64 mg/LModerately hard

Pierce County

Fife is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.

See all of Pierce County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Fife, WA water: common questions

Do I need a water softener in Fife?

Probably not. Water measured around Fife is 4.1 gpg (70 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 8,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Fife's drinking water?

The main public water system serving Fife in EPA records is Fife Dept of Public Works. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Fife?

It depends on what you want to remove. In Fife, EPA testing found PFHxS and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next