Water hardness in Harker Heights, TX
Water in Harker Heights is very hard, with a median of 291 mg/L (17 grains per gallon) across 3 monitoring sites within 10 miles.
Harker Heights tap water at a glance
- HardnessVery hard (291 mg/L, 17 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS3 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 2,852 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 291 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 17 gpg (16.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Harker Heights
Prefilled with Harker Heights's measured local hardness of 291 mg/L (17 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Harker Heights tap water
City of Harker Heights is the main public water system for Harker Heights. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2023 – May 2024. 3 PFAS were detected. Every result with a federal limit was at or below it.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 8 ppt | 4 of 4 samples | — |
| PFHxS perfluorohexane sulfonic acid | 4.8 ppt | 2 of 4 samples | 10 ppt* |
| PFBS perfluorobutane sulfonic acid | 3.4 ppt | 1 of 4 samples | — |
Other water systems serving parts of Harker Heights
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Belton serves over 10,000 people | PFBA, PFPeA, PFHxS +1 more | — | May 2023 – Mar 2024 |
| City of Temple serves over 10,000 people | PFBA, PFHxA, PFPeA +3 more | ND / 4.9 ppt | Jan 2023 – Mar 2024 |
| City of Killeen serves over 10,000 people | PFBA, PFPeA, PFBS | — | Mar 2025 – Dec 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Harker Heights
City of Harker Heights reported 12,878 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 105 are galvanized lines that must be replaced, and 2,852 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Harker Heights whether your address is on its list.
Other water systems serving parts of Harker Heights
| Water system | Service lines | Total |
|---|---|---|
| City of Belton | 0 lead · 0 galvanized · 3,036 unknown | 8,842 |
| City of Temple | 0 lead · 0 galvanized · 127 unknown | 24,402 |
| City of Killeen | 0 lead · 2,426 galvanized · 0 unknown | 56,364 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Harker Heights drinking water violations
EPA records show no health-based violations for City of Harker Heights since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Harker Heights
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Belton | None | 0 |
| City of Temple | 22 | 3 |
| City of Killeen | None | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Harker Heights
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| AX-40-58-903 (CUWCD E-06-063P) USGS Texas Water Science Center | Well | 7.3 mi | 220 mg/L | 2 | 2021 |
| AX-58-04-515 USGS Texas Water Science Center | Spring | 9.9 mi | 292 mg/L | 3 | 2012–2015 |
| Domestic well nr IH-35 and Salado Ck USGS Texas Water Science Center | Well | 9.9 mi | 291 mg/L | 1 | 2015 |
Water hardness in towns near Harker Heights
| Town | Distance | Median | Class |
|---|---|---|---|
| Killeen | 5 mi | 220 mg/L | Very hard |
| Belton | 10 mi | 287 mg/L | Very hard |
| Fort Hood | 10 mi | 311 mg/L | Very hard |
| Temple | 15 mi | 285 mg/L | Very hard |
| Copperas Cove | 17 mi | 311 mg/L | Very hard |
| Georgetown | 27 mi | 326 mg/L | Very hard |
| Gatesville | 27 mi | 311 mg/L | Very hard |
| Liberty Hill | 31 mi | 322 mg/L | Very hard |
| Leander | 36 mi | 340 mg/L | Very hard |
| Taylor | 36 mi | 322 mg/L | Very hard |
Bell County
Harker Heights is in Bell County, where the median is 285 mg/L (very hard) across 18 sites.
See all of Bell County →Harker Heights, TX water: common questions
Do I need a water softener in Harker Heights?
Very likely. Water measured around Harker Heights is 17 gpg (291 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 30,000 grains.Size it for your household →
Who supplies Harker Heights's drinking water?
The main public water system serving Harker Heights in EPA records is City of Harker Heights. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Harker Heights?
It depends on what you want to remove. In Harker Heights, EPA testing found PFBA, PFHxS and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 3 PFAS in Harker Heights's main water system.
- How to tell if your home has a lead pipe2,852 service lines here are of unknown material.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.