Water hardness in Belton, TX
Water in Belton is very hard, with a median of 287 mg/L (16.8 grains per gallon) across 12 monitoring sites within 10 miles.
Belton tap water at a glance
- HardnessVery hard (287 mg/L, 16.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS4 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 3,036 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 287 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 16.8 gpg (16.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Belton
Prefilled with Belton's measured local hardness of 287 mg/L (16.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Belton tap water
City of Belton is the main public water system for Belton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Mar 2024. 4 PFAS were detected. Every result with a federal limit was at or below it.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 9.8 ppt | 3 of 4 samples | — |
| PFPeA perfluoropentanoic acid | 3.8 ppt | 2 of 4 samples | — |
| PFHxS perfluorohexane sulfonic acid | 3.7 ppt | 3 of 4 samples | 10 ppt* |
| PFBS perfluorobutane sulfonic acid | 3.4 ppt | 1 of 4 samples | — |
Other water systems serving parts of Belton
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Temple serves over 10,000 people | PFBA, PFHxA, PFPeA +3 more | ND / 4.9 ppt | Jan 2023 – Mar 2024 |
| Kempner WSC serves over 10,000 people | PFBA, PFBS, PFPeA | — | May 2024 – May 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Belton
City of Belton reported 8,842 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3,036 lines are still of unknown material.
Other water systems serving parts of Belton
| Water system | Service lines | Total |
|---|---|---|
| City of Temple | 0 lead · 0 galvanized · 127 unknown | 24,402 |
| Kempner WSC | 0 lead · 0 galvanized · 0 unknown | 5,797 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Belton drinking water violations
EPA records show no health-based violations for City of Belton since 2016.
Other water systems serving parts of Belton
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Temple | 22 | 3 |
| Kempner WSC | 9 | 3 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Belton
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| AX-58-04-6xx USGS Texas Water Science Center | Spring | 8.1 mi | 282 mg/L | 2 | 2012–2015 |
| Salado Ck at Salado, TX USGS Texas Water Science Center | Stream | 8.1 mi | 240 mg/L | 3 | 2013–2014 |
| AX-58-04-614 USGS Texas Water Science Center | Spring | 8.1 mi | 280 mg/L | 2 | 2012–2015 |
| AX-58-04-630 USGS Texas Water Science Center | Spring | 8.2 mi | 290 mg/L | 2 | 2012–2015 |
| AX-58-04-613 USGS Texas Water Science Center | Spring | 8.3 mi | 285 mg/L | 2 | 2012–2015 |
| AX-58-04-629 USGS Texas Water Science Center | Spring | 8.3 mi | 286 mg/L | 12 | 2012–2015 |
Water hardness in towns near Belton
| Town | Distance | Median | Class |
|---|---|---|---|
| Temple | 6 mi | 285 mg/L | Very hard |
| Harker Heights | 10 mi | 291 mg/L | Very hard |
| Killeen | 15 mi | 220 mg/L | Very hard |
| Fort Hood | 19 mi | 311 mg/L | Very hard |
| Copperas Cove | 26 mi | 311 mg/L | Very hard |
| Georgetown | 30 mi | 326 mg/L | Very hard |
| Gatesville | 31 mi | 311 mg/L | Very hard |
| Hewitt | 32 mi | 150 mg/L | Hard |
| Taylor | 33 mi | 322 mg/L | Very hard |
| Robinson | 35 mi | 150 mg/L | Hard |
Bell County
Belton is in Bell County, where the median is 285 mg/L (very hard) across 18 sites.
See all of Bell County →Belton, TX water: common questions
Do I need a water softener in Belton?
Very likely. Water measured around Belton is 16.8 gpg (287 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 29,000 grains.Size it for your household →
Who supplies Belton's drinking water?
The main public water system serving Belton in EPA records is City of Belton. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Belton?
It depends on what you want to remove. In Belton, EPA testing found PFBA, PFPeA and PFHxS and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 4 PFAS in Belton's main water system.
- How to tell if your home has a lead pipe3,036 service lines here are of unknown material.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.