Water hardness in Killeen, TX

Water in Killeen is very hard, with a median of 220 mg/L (12.8 grains per gallon) across 3 monitoring sites within 10 miles.

13% harder than the Texas median (194 mg/L) 97th hardest of 251 Texas towns Population 159,643
220mg/L
12.8 grains per gallon
Very hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Killeen can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Killeen tap water at a glance

  • HardnessVery hard (220 mg/L, 12.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS3 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 220 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.8 gpg (12.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples5
Sample years2015–2021
Middle 50% of sites120–430 mg/L
Groundwater (wells, springs)220 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Killeen

Prefilled with Killeen's measured local hardness of 220 mg/L (12.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Killeen tap water

City of Killeen is the main public water system for Killeen. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Mar 2025 – Dec 2025. 3 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
7.3 ppt 4 of 8 samples —
PFPeA
perfluoropentanoic acid
3.5 ppt 3 of 8 samples —
PFBS
perfluorobutane sulfonic acid
3 ppt 1 of 8 samples —

Other water systems serving parts of Killeen

Water systemPFAS detectedHighest PFOA / PFOSTested
Kempner WSC
serves over 10,000 people
PFBA, PFBS, PFPeA — May 2024 – May 2025
City of Harker Heights
serves over 10,000 people
PFBA, PFHxS, PFBS — Mar 2023 – May 2024
US ARMY South Fort Hood
serves over 10,000 people
PFBA, PFHxS, PFPeA +1 more — Nov 2023 – Aug 2024
City of Georgetown
serves over 10,000 people
PFBA, PFPeA, PFHxA +4 more 4.9 / 5.7 ppt Jun 2023 – Feb 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Killeen

City of Killeen reported 56,364 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 2,426 are galvanized lines that must be replaced.

0lead (0%)
2,426galvanized requiring replacement
0unknown material (0%)
53,938not lead (96%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Killeen whether your address is on its list.

Other water systems serving parts of Killeen

Water systemService linesTotal
Kempner WSC0 lead · 0 galvanized · 0 unknown5,797
City of Harker Heights0 lead · 105 galvanized · 2,852 unknown12,878
US ARMY South Fort Cavazos0 lead · 0 galvanized · 0 unknown7,041
City of Georgetown0 lead · 161 galvanized · 4 unknown62,099

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Killeen drinking water violations

EPA records show no health-based violations for City of Killeen since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Killeen

Water systemHealth-based violationsMonitoring/reporting
Kempner WSC93
City of Harker HeightsNone1
US ARMY South Fort HoodNone0
City of Georgetown12

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Killeen

SiteTypeDistanceMedianSamplesYears
AX-40-58-903 (CUWCD E-06-063P)
USGS Texas Water Science Center
Well 4 mi220 mg/L22021
AX-40-58-201
USGS Texas Water Science Center
Well 5.6 mi640 mg/L12015
AX-58-02-304 (CUWCD M-19-002P)
USGS Texas Water Science Center
Well 8.5 mi21 mg/L22021

Water hardness in towns near Killeen

TownDistanceMedianClass
Fort Hood5 mi 311 mg/LVery hard
Harker Heights5 mi 291 mg/LVery hard
Copperas Cove11 mi 311 mg/LVery hard
Belton15 mi 287 mg/LVery hard
Temple20 mi 285 mg/LVery hard
Gatesville25 mi 311 mg/LVery hard
Georgetown28 mi 326 mg/LVery hard
Liberty Hill30 mi 322 mg/LVery hard
Leander36 mi 340 mg/LVery hard
Round Rock38 mi 366 mg/LVery hard

Bell County

Killeen is in Bell County, where the median is 285 mg/L (very hard) across 18 sites.

See all of Bell County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Killeen, TX water: common questions

Do I need a water softener in Killeen?

Very likely. Water measured around Killeen is 12.8 gpg (220 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 23,000 grains.Size it for your household →

Who supplies Killeen's drinking water?

The main public water system serving Killeen in EPA records is City of Killeen. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Killeen?

It depends on what you want to remove. In Killeen, EPA testing found PFBA, PFPeA and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next