Water hardness in Taylor, TX
Water in Taylor is very hard, with a median of 322 mg/L (18.8 grains per gallon) across Williamson County.
There are not enough monitoring sites within 10 miles of Taylor, so this page uses the Williamson County median.
Taylor tap water at a glance
- HardnessVery hard (322 mg/L, 18.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS5 found; the highest PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo known lead lines; 2,575 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 322 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 18.8 gpg (18 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Taylor
Prefilled with Taylor's measured local hardness of 322 mg/L (18.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Taylor tap water
City of Taylor is the main public water system for Taylor. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2023 – Jul 2024. 5 PFAS were detected. The highest PFOA result was above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFPeA perfluoropentanoic acid | 18.8 ppt | 4 of 4 samples | — |
| PFBA perfluorobutanoic acid | 10.3 ppt | 4 of 4 samples | — |
| PFBS perfluorobutane sulfonic acid | 9.4 ppt | 4 of 4 samples | — |
| PFHxA perfluorohexanoic acid | 8.9 ppt | 4 of 4 samples | — |
| PFOA perfluorooctanoic acid | 5 ppt | 2 of 4 samples | 4 ppt |
Other water systems serving parts of Taylor
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Manville WSC serves over 10,000 people | PFNA, PFOS, PFBS +7 more | 5.9 / 12.4 ppt | Feb 2023 – Nov 2023 |
| Jonah Water Sud serves over 10,000 people | PFPeA, PFBA, PFBS +4 more | 5.1 / 5.7 ppt | May 2023 – Mar 2024 |
| Southwest Milam WSC serves over 10,000 people | None detected | — | Apr 2023 – Oct 2023 |
| City of Hutto serves over 10,000 people | None detected | — | Oct 2023 – Jul 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Taylor
City of Taylor reported 6,979 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 17 are galvanized lines that must be replaced, and 2,575 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Taylor whether your address is on its list.
Other water systems serving parts of Taylor
| Water system | Service lines | Total |
|---|---|---|
| Manville WSC | 0 lead · 0 galvanized · 0 unknown | 12,511 |
| Jonah Water Sud | 0 lead · 0 galvanized · 0 unknown | 14,301 |
| Southwest Milam WSC | 0 lead · 0 galvanized · 0 unknown | 3,914 |
| City of Hutto | 0 lead · 0 galvanized · 216 unknown | 7,728 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Taylor drinking water violations
EPA records show no health-based violations for City of Taylor since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Taylor
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Manville WSC | 5 | 6 |
| Jonah Water Sud | 2 | 1 |
| Southwest Milam WSC | None | 2 |
| City of Hutto | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Water hardness in towns near Taylor
| Town | Distance | Median | Class |
|---|---|---|---|
| Hutto | 7 mi | 332 mg/L | Very hard |
| Pflugerville | 13 mi | 332 mg/L | Very hard |
| Round Rock | 14 mi | 366 mg/L | Very hard |
| Elgin | 15 mi | 180 mg/L | Hard |
| Manor | 17 mi | 323 mg/L | Very hard |
| Georgetown | 17 mi | 326 mg/L | Very hard |
| Wells Branch | 17 mi | 370 mg/L | Very hard |
| Brushy Creek | 19 mi | 356 mg/L | Very hard |
| Cedar Park | 23 mi | 351 mg/L | Very hard |
| Leander | 26 mi | 340 mg/L | Very hard |
Williamson County
Taylor is in Williamson County, where the median is 322 mg/L (very hard) across 20 sites.
See all of Williamson County →Taylor, TX water: common questions
Do I need a water softener in Taylor?
Very likely. Water measured around Taylor is 18.8 gpg (322 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 33,000 grains.Size it for your household →
Who supplies Taylor's drinking water?
The main public water system serving Taylor in EPA records is City of Taylor. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Taylor?
It depends on what you want to remove. In Taylor, EPA testing found PFPeA, PFBA and PFBS and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 5 PFAS in Taylor's main water system.
- How to tell if your home has a lead pipe2,575 service lines here are of unknown material.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.